On OMAP platforms the device needs to be runtime resumed before it can be accessed. The OMAP HWMOD framework takes care of enabling the module and its resources based on the device's runtime PM state. In this patch we runtime resume during .probe() and runtime suspend during .remove() (i.e. ahci_host_stop()). We also update the runtime PM state during .resume(). Signed-off-by: Roger Quadros <rogerq@xxxxxx> Signed-off-by: Balaji T K <balajitk@xxxxxx> --- drivers/ata/ahci_platform.c | 12 ++++++++++++ 1 file changed, 12 insertions(+) diff --git a/drivers/ata/ahci_platform.c b/drivers/ata/ahci_platform.c index f61093b..04c4ac2 100644 --- a/drivers/ata/ahci_platform.c +++ b/drivers/ata/ahci_platform.c @@ -23,6 +23,7 @@ #include <linux/platform_device.h> #include <linux/libata.h> #include <linux/ahci_platform.h> +#include <linux/pm_runtime.h> #include "ahci.h" static void ahci_host_stop(struct ata_host *host); @@ -142,6 +143,9 @@ static int ahci_probe(struct platform_device *pdev) } } + pm_runtime_enable(dev); + pm_runtime_get_sync(dev); + hpriv->phy = devm_phy_get(dev, "sata-phy"); if (IS_ERR(hpriv->phy)) { dev_dbg(dev, "can't get sata-phy\n"); @@ -269,6 +273,9 @@ static void ahci_host_stop(struct ata_host *host) clk_disable_unprepare(hpriv->clk); clk_put(hpriv->clk); } + + pm_runtime_put_sync(dev); + pm_runtime_disable(dev); } #ifdef CONFIG_PM_SLEEP @@ -340,6 +347,11 @@ static int ahci_resume(struct device *dev) ata_host_resume(host); + /* We resumed so update PM runtime state */ + pm_runtime_disable(dev); + pm_runtime_set_active(dev); + pm_runtime_enable(dev); + return 0; disable_unprepare_clk: -- 1.8.3.2 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html