On Wed, Apr 5, 2017 at 1:30 PM, Rob Herring <robh@xxxxxxxxxx> wrote: > This series adds serdev support to the HCI LL protocol used on TI BT > modules and enables support on HiKey board with with the WL1835 module. > With this the custom TI UIM daemon and btattach are no longer needed. Without UIM daemon, what instruction do you use to load the BT firmware? I was thinking 'hciattach' but I was having trouble. I was hoping you might have some insight. hciattach -t 30 -s 115200 /dev/ttymxc1 texas 3000000 flow Just returns a timeout. I modified my i.MX6 device tree per the binding documentation and setup the regulators and enable GPIO pins. adam > > The series is available on this git branch[1]. Patch 2 is just clean-up > and can be applied independently. Patch 3 is dependent on the series > "Nokia H4+ support". I'd suggest both series are merged thru the BT tree. > > Rob > > [1] git://git.kernel.org/pub/scm/linux/kernel/git/robh/linux.git ti-bluetooth > > Rob Herring (4): > dt-bindings: net: Add TI WiLink shared transport binding > bluetooth: hci_uart: remove unused hci_uart_init_tty > bluetooth: hci_uart: add LL protocol serdev driver support > arm64: dts: hikey: add WL1835 Bluetooth device node > > .../devicetree/bindings/net/ti,wilink-st.txt | 35 +++ > arch/arm64/boot/dts/hisilicon/hi6220-hikey.dts | 5 + > drivers/bluetooth/hci_ldisc.c | 19 -- > drivers/bluetooth/hci_ll.c | 261 ++++++++++++++++++++- > drivers/bluetooth/hci_uart.h | 1 - > 5 files changed, 300 insertions(+), 21 deletions(-) > create mode 100644 Documentation/devicetree/bindings/net/ti,wilink-st.txt > > -- > 2.10.1 > > > _______________________________________________ > linux-arm-kernel mailing list > linux-arm-kernel@xxxxxxxxxxxxxxxxxxx > http://lists.infradead.org/mailman/listinfo/linux-arm-kernel -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
