The Bananapi M2 Plus has a USB OTG port that can be used in both powered host mode and peripheral mode. When in peripheral mode, the port does not power the board. There is no VBUS sensing on the port. This patch adds the regulator controlling VBUS on the OTG port, the GPIO for the ID detect pin, and enables the USB OTG and host controllers. Signed-off-by: Chen-Yu Tsai <wens@xxxxxxxx> --- arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts | 22 +++++++++++++++++++++- 1 file changed, 21 insertions(+), 1 deletion(-) diff --git a/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts b/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts index 52acbe111cad..17c7c088cdea 100644 --- a/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts +++ b/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts @@ -92,6 +92,10 @@ }; }; +&ehci0 { + status = "okay"; +}; + &ehci1 { status = "okay"; }; @@ -145,6 +149,10 @@ status = "okay"; }; +&ohci0 { + status = "okay"; +}; + &ohci1 { status = "okay"; }; @@ -170,6 +178,11 @@ }; }; +®_usb0_vbus { + gpio = <&pio 3 11 GPIO_ACTIVE_HIGH>; /* PD11 */ + status = "okay"; +}; + &uart0 { pinctrl-names = "default"; pinctrl-0 = <&uart0_pins_a>; @@ -182,7 +195,14 @@ status = "okay"; }; +&usb_otg { + dr_mode = "otg"; + status = "okay"; +}; + &usbphy { - /* USB VBUS is on as long as VCC-IO is on */ + usb0_id_det-gpios = <&r_pio 0 6 GPIO_ACTIVE_HIGH>; /* PL6 */ + usb0_vbus-supply = <®_usb0_vbus>; + /* USB host VBUS is on as long as VCC-IO is on */ status = "okay"; }; -- 2.11.0 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html