From: Niklas Cassel <niklas.cassel@xxxxxxxx> The hardware has a LPI interrupt. There is already code in the stmmac driver to parse and handle the interrupt. However, this information was missing from the DT binding. Signed-off-by: Niklas Cassel <niklas.cassel@xxxxxxxx> --- Documentation/devicetree/bindings/net/stmmac.txt | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/Documentation/devicetree/bindings/net/stmmac.txt b/Documentation/devicetree/bindings/net/stmmac.txt index f652b0c384ce..84e4cbfd3b0f 100644 --- a/Documentation/devicetree/bindings/net/stmmac.txt +++ b/Documentation/devicetree/bindings/net/stmmac.txt @@ -8,8 +8,8 @@ Required properties: that services interrupts for this device - interrupts: Should contain the STMMAC interrupts - interrupt-names: Should contain the interrupt names "macirq" - "eth_wake_irq" if this interrupt is supported in the "interrupts" - property + "eth_wake_irq" if this interrupt is supported in the "interrupts" property + "eth_lpi" if this interrupt is supported in the "interrupts" property - phy-mode: See ethernet.txt file in the same directory. - snps,reset-gpio gpio number for phy reset. - snps,reset-active-low boolean flag to indicate if phy reset is active low. @@ -152,8 +152,8 @@ Examples: compatible = "st,spear600-gmac"; reg = <0xe0800000 0x8000>; interrupt-parent = <&vic1>; - interrupts = <24 23>; - interrupt-names = "macirq", "eth_wake_irq"; + interrupts = <24 23 22>; + interrupt-names = "macirq", "eth_wake_irq", "eth_lpi"; mac-address = [000000000000]; /* Filled in by U-Boot */ max-frame-size = <3800>; phy-mode = "gmii"; -- 2.11.0 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
