Rafael J. Wysocki wrote:
On Tue, Mar 14, 2017 at 10:16 PM, Sakari Ailus
<sakari.ailus@xxxxxxxxxxxxxxx> wrote:
Rafael J. Wysocki wrote:
On Tue, Mar 14, 2017 at 6:54 PM, Sakari Ailus
<sakari.ailus@xxxxxxxxxxxxxxx> wrote:
Hi Rafael,
Rafael J. Wysocki wrote:
On Tue, Mar 14, 2017 at 9:09 AM, Sakari Ailus
<sakari.ailus@xxxxxxxxxxxxxxx> wrote:
On 03/14/17 10:08, Sakari Ailus wrote:
How about this instead:
All port nodes are located under the device's "_DSD" node in the
hierarchical data extension tree. The property extension related to
each port node must contain the key "port" and an integer value which
is the number of the port.
So with matching strings instead of indices, this will change, too...
It doesn't have to AFAICS, but the number is just redundant IMO. You
only need a boolean property saying "this is a port", so you know that
you should expect a list of endpoints in that object.
No, it's not redundant. It's the number of the physical port in the
device
--- this is how the driver gets to know where the connection has been
made.
OK, but what exactly do you mean by "physical port"?
The device (or an IP block) has physical interfaces to the world outside.
There could be just one, but there may be more. For an ISP, there could be
e.g. four CSI-2 receivers to each of which you could connect a camera
sensor. So for an ISP device, that number tells which of the receivers a
given sensor is connected to.
The mapping between this number and what the hardware datasheet refers to
needs to be documented per device.
OK, so the number actually is an arbitrary piece of data associated
with the key "port" and the interpretation of that piece of data
depends on whoever asks for that value.
IOW, the core doesn't care.
With all due respect to whoever invented this on the DT side, this is
just bad design to me, because it causes the "port" property to serve
two different purposes at the same time. First, it tells the core
that this object is a port. Second, it is expected to provide a piece
of data of unspecified interpretation to somebody. Which means that
the "port" property is both general and device-specific at the same
time and the sanity of that is quite questionable IMO.
DT uses a node called either "port" or "ports" to store the port nodes.
The reg property tells the number of the port (see
Documentation/devicetree/bindings/graph.txt). I'm no DT expert, but my
understanding is that the node namespace is different from the property
namespace.
If you're concerned of possible double meanings, it's entirely possible
to put the port nodes under hierarchical data extension named e.g.
"ports", and document that this is what the node must be called (single
port node could be just called "port"). This way, it should be much more
difficult to interpret a non-port node as a port node --- roughly
equivalent of the DT ports node.
The drawback with this change is that the size of the data structure in
ASL (and AML) will grow.
--
Sakari Ailus
sakari.ailus@xxxxxxxxxxxxxxx
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
