On Fri, Feb 17, 2017 at 11:39:11AM +0100, Philipp Zabel wrote: > On Thu, 2017-02-16 at 22:57 +0000, Russell King - ARM Linux wrote: > > On Thu, Feb 16, 2017 at 02:27:41PM -0800, Steve Longerbeam wrote: > > > > > > > > > On 02/16/2017 02:20 PM, Russell King - ARM Linux wrote: > > > >On Wed, Feb 15, 2017 at 06:19:02PM -0800, Steve Longerbeam wrote: > > > >>In version 4: > > > > > > > >With this version, I get: > > > > > > > >[28762.892053] imx6-mipi-csi2: LP-11 timeout, phy_state = 0x00000000 > > > >[28762.899409] ipu1_csi0: pipeline_set_stream failed with -110 > > > > > > > > > > Right, in the imx219, on exit from s_power(), the clock and data lanes > > > must be placed in the LP-11 state. This has been done in the ov5640 and > > > tc358743 subdevs. > > > > The only way to do that is to enable streaming from the sensor, wait > > an initialisation time, and then disable streaming, and wait for the > > current line to finish. There is _no_ other way to get the sensor to > > place its clock and data lines into LP-11 state. > > I thought going through LP-11 is part of the D-PHY transmitter > initialization, during the LP->HS wakeup sequence. But then I have no > access to MIPI specs. The D-PHY transmitter initialisation *only* happens as part of the wake-up from standby to streaming mode. That is because Sony expect that you program the sensor, and then when you switch it to streaming mode, it computes the D-PHY parameters from the PLL, input clock rate (you have to tell it the clock rate in 1/256 MHz units), number of lanes, and other parameters. It is possible to program the D-PHY parameters manually, but that doesn't change the above sequence in any way (it just avoids the chip computing the values, it doesn't result in any change of behaviour on the bus.) The IMX219 specifications are clear: the clock and data lines are held low (LP-00 state) after releasing the hardware enable signal. There's a period of chip initialisation, and then you can access the I2C bus and configure it. There's a further period of initialisation where charge pumps are getting to their operating state. Then, you set the streaming bit, and a load more initialisation happens before the CSI bus enters LP-11 state and the first frame pops out. When entering standby, the last frame is completed, and then the CSI bus enters LP-11 state. SMIA are slightly different - mostly following what I've said above, but the clock and data lines are tristated after releasing the xshutdown signal, and they remain tristated until the clock line starts toggling before the first frame appears. There appears to be no point that the clock line enters LP-11 state before it starts toggling. When entering standby, the last frame is completed, and the CSI bus enters tristate mode (so floating.) There is no way to get these sensors into LP-11 state. -- RMK's Patch system: http://www.armlinux.org.uk/developer/patches/ FTTC broadband for 0.8mile line: currently at 9.6Mbps down 400kbps up according to speedtest.net. -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
