This series updates/adds Device Tree support for I2SE's Duckbill device family. The Duckbill devices are small, pen-drive sized boards based on NXP's i.MX28 SoC. While the initial variants (Duckbill series) were equipped with a micro SD card slot only, the latest generation (Duckbill 2 series) have an additional internal eMMC onboard. Both device generations consists of four "family members": - Duckbill/Duckbill 2: generic board, intended to be used as baseboard for custom designs and/or as development board - Duckbill EnOcean/Duckbill 2 EnOcean: come with an EnOcean daugther board equipped with the popular TCM310 module - Duckbill 485/Duckbill 2 485: as the name implies, these devices are intended to be used as Ethernet - RS485 converters - Duckbill SPI/Duckbill 2 SPI: not sold separately, but used in I2SE's development kits for Green PHY HomePlug Powerline communication Because the Duckbill series is EOL, this patch series only adds support for the latest Duckbill 2 series devices. However, support for the generic Duckbill board was already mainline, so update it to match vendor tree DT. Changes since v2: - re-ordered documentation patch and fixed typos - re-worded some commit messages to better reflect patch content - fixed Makefile beginner issues - added Acked-bys where applicable Changes since v1: - dropped device tree include (shared common definitions) - added patch 9 (DT documentation file) - applied reviewers hints - rebased Michael Heimpold (9): ARM: dts: imx28: add alternative pinmuxing for mmc2 ARM: dts: imx28: rename mmc2_sck_cfg ARM: dts: imx28: add alternative muxing for mmc2_sck_cfg ARM: dts: imx28-duckbill: update to match vendor distributed DT Documentation: DT: add entries for I2SE boards ARM: dts: add support for I2SE Duckbill 2 boards ARM: dts: add support for I2SE Duckbill 2 485 ARM: dts: add support for I2SE Duckbill 2 EnOcean ARM: dts: add support for I2SE Duckbill 2 SPI Documentation/devicetree/bindings/arm/i2se.txt | 22 +++ arch/arm/boot/dts/Makefile | 4 + arch/arm/boot/dts/imx28-duckbill-2-485.dts | 189 +++++++++++++++++++++ arch/arm/boot/dts/imx28-duckbill-2-enocean.dts | 220 +++++++++++++++++++++++++ arch/arm/boot/dts/imx28-duckbill-2-spi.dts | 199 ++++++++++++++++++++++ arch/arm/boot/dts/imx28-duckbill-2.dts | 183 ++++++++++++++++++++ arch/arm/boot/dts/imx28-duckbill.dts | 81 ++++++--- arch/arm/boot/dts/imx28-m28cu3.dts | 2 +- arch/arm/boot/dts/imx28.dtsi | 28 +++- 9 files changed, 901 insertions(+), 27 deletions(-) create mode 100644 Documentation/devicetree/bindings/arm/i2se.txt create mode 100644 arch/arm/boot/dts/imx28-duckbill-2-485.dts create mode 100644 arch/arm/boot/dts/imx28-duckbill-2-enocean.dts create mode 100644 arch/arm/boot/dts/imx28-duckbill-2-spi.dts create mode 100644 arch/arm/boot/dts/imx28-duckbill-2.dts -- 2.6.1 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
