On Fri, Jan 20, 2017 at 2:31 PM, Neil Armstrong <narmstrong@xxxxxxxxxxxx> wrote: > On 01/20/2017 02:26 PM, Martin Blumenstingl wrote: >> This resets the ethernet PHY during boot to get the PHY into a "clean" >> state. >> While here also specify the phy-handle of the ethmac node to make the >> PHY configuration similar to the one we have on GXL devices. This will >> allow us to specify OF-properties for the PHY itself. >> >> Signed-off-by: Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx> >> --- >> arch/arm64/boot/dts/amlogic/meson-gxbb-p201.dts | 24 ++++++++++++++++++++++++ >> 1 file changed, 24 insertions(+) >> >> diff --git a/arch/arm64/boot/dts/amlogic/meson-gxbb-p201.dts b/arch/arm64/boot/dts/amlogic/meson-gxbb-p201.dts >> index 39bb037a3e47..5d2cd2ecfdc4 100644 >> --- a/arch/arm64/boot/dts/amlogic/meson-gxbb-p201.dts >> +++ b/arch/arm64/boot/dts/amlogic/meson-gxbb-p201.dts >> @@ -50,3 +50,27 @@ >> compatible = "amlogic,p201", "amlogic,meson-gxbb"; >> model = "Amlogic Meson GXBB P201 Development Board"; >> }; >> + >> +ðmac { >> + status = "okay"; >> + pinctrl-0 = <ð_rgmii_pins>; >> + pinctrl-names = "default"; >> + phy-handle = <ð_phy0>; >> + phy-mode = "rgmii"; >> + >> + snps,reset-gpio = <&gpio GPIOZ_14 0>; >> + snps,reset-delays-us = <0 10000 1000000>; >> + snps,reset-active-low; >> + >> + mdio { >> + compatible = "snps,dwmac-mdio"; >> + #address-cells = <1>; >> + #size-cells = <0>; >> + >> + eth_phy0: ethernet-phy@0 { >> + compatible = "ethernet-phy-id0022.1620", >> + "ethernet-phy-ieee802.3-c22"; >> + reg = <3>; >> + }; >> + }; >> +}; >> > > Hi Martin, > > It seems you mismatched the p200 and the p201, it's the p201 nobody has and uses a rmii link. ouch, good catch. I'll send a fix for that later - thanks for spotting! -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html