On 9/01/2017 15:54, Peter Rosin wrote:
On 2017-01-05 05:11, Phil Reid wrote:
Unfortunately some hardware device will assert their irq line immediately
on power on and provide no mechanism to mask the irq. As the i2c muxes
provide no method to mask irq line this provides a work around by keeping
the parent irq masked until enough device drivers have loaded to service
all pending interrupts.
For example the the ltc1760 assert its SMBALERT irq immediately on power
on. With two ltc1760 attached to bus 0 & 1 on a pca954x mux when the first
device is registered irq are enabled and fire continuously as the second
device driver has not yet loaded. Setting this parameter to 0x3 while
delay the irq being enabled until both devices are ready.
Acked-by: Peter Rosin <peda@xxxxxxxxxx>
Ooops, too soon apparently, but the below nitpicks are not that important.
Maybe Wolfram can fix it up instead of you sending a new version?
G'day Peter,
I've done a v3 with those changes. And added your ack to p1.
Regards
Phil
Cheers,
peda
Signed-off-by: Phil Reid <preid@xxxxxxxxxxxxxxxxx>
---
drivers/i2c/muxes/i2c-mux-pca954x.c | 22 +++++++++++++++++++++-
1 file changed, 21 insertions(+), 1 deletion(-)
diff --git a/drivers/i2c/muxes/i2c-mux-pca954x.c b/drivers/i2c/muxes/i2c-mux-pca954x.c
index 84fc767..581a75d 100644
--- a/drivers/i2c/muxes/i2c-mux-pca954x.c
+++ b/drivers/i2c/muxes/i2c-mux-pca954x.c
@@ -75,6 +75,19 @@ struct chip_desc {
} muxtype;
};
+/*
+ * irq_mask_enable: Provides a mechanism to work around hardware that asserts
+ * their irq immediately on power on. It allows the enabling of the irq to be
double space: "the irq"
+ * delayed until the corresponding bits in the the irq_mask are set thru
+ * irq_unmask.
+ * For example the the ltc1760 assert its SMBALERT irq immediately on power
"the the"
+ * on. With two ltc1760 attached to bus 0 & 1 on a pca954x mux when the first
+ * device is registered irq are enabled and fire continuously as the second
+ * device driver has not yet loaded. Setting this parameter to 0x3 while
+ * delay the irq being enabled until both devices are ready.
+ * This workaround will not work if two devices share an interrupt on the
+ * same bus segment.
+ */
struct pca954x {
const struct chip_desc *chip;
@@ -84,6 +97,7 @@ struct pca954x {
struct irq_domain *irq;
unsigned int irq_mask;
+ unsigned int irq_mask_enable;
};
/* Provide specs for the PCA954x types we know about */
@@ -270,9 +284,12 @@ static void pca954x_irq_unmask(struct irq_data *idata)
struct pca954x *data = irq_data_get_irq_chip_data(idata);
unsigned int pos = idata->hwirq;
- if (!data->irq_mask)
+ if (!data->irq_mask_enable && !data->irq_mask)
enable_irq(data->client->irq);
data->irq_mask |= BIT(pos);
+ if (data->irq_mask_enable &&
+ (data->irq_mask & data->irq_mask) == data->irq_mask_enable)
+ enable_irq(data->client->irq);
}
static int pca954x_irq_set_type(struct irq_data *idata, unsigned int type)
@@ -395,6 +412,9 @@ static int pca954x_probe(struct i2c_client *client,
idle_disconnect_dt = of_node &&
of_property_read_bool(of_node, "i2c-mux-idle-disconnect");
+ of_property_read_u32(of_node, "nxp,irq-mask-enable",
+ &data->irq_mask_enable);
+
ret = pca954x_irq_setup(muxc);
if (ret)
goto fail_del_adapters;
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
