This adds documentation of the device tree bindings of the Lattice iCE40 FPGA driver for the FPGA manager framework. Signed-off-by: Joel Holdsworth <joel@xxxxxxxxxxxxxxxxxxx> Acked-by: Rob Herring <robh@xxxxxxxxxx> Acked-by: Alan Tull <atull@xxxxxxxxxxxxxxxxxxxxx> Acked-by: Moritz Fischer <moritz.fischer@xxxxxxxxx> Acked-by: Marek Vasut <marex@xxxxxxx> --- .../bindings/fpga/lattice-ice40-fpga-mgr.txt | 21 +++++++++++++++++++++ 1 file changed, 21 insertions(+) create mode 100644 Documentation/devicetree/bindings/fpga/lattice-ice40-fpga-mgr.txt diff --git a/Documentation/devicetree/bindings/fpga/lattice-ice40-fpga-mgr.txt b/Documentation/devicetree/bindings/fpga/lattice-ice40-fpga-mgr.txt new file mode 100644 index 0000000..4dc4124 --- /dev/null +++ b/Documentation/devicetree/bindings/fpga/lattice-ice40-fpga-mgr.txt @@ -0,0 +1,21 @@ +Lattice iCE40 FPGA Manager + +Required properties: +- compatible: Should contain "lattice,ice40-fpga-mgr" +- reg: SPI chip select +- spi-max-frequency: Maximum SPI frequency (>=1000000, <=25000000) +- cdone-gpios: GPIO input connected to CDONE pin +- reset-gpios: Active-low GPIO output connected to CRESET_B pin. Note + that unless the GPIO is held low during startup, the + FPGA will enter Master SPI mode and drive SCK with a + clock signal potentially jamming other devices on the + bus until the firmware is loaded. + +Example: + fpga: fpga@0 { + compatible = "lattice,ice40-fpga-mgr"; + reg = <0>; + spi-max-frequency = <1000000>; + cdone-gpios = <&gpio 24 GPIO_ACTIVE_HIGH>; + reset-gpios = <&gpio 22 GPIO_ACTIVE_LOW>; + }; -- 2.7.4 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html