Re: [PATCH v2 04/19] ARM: dts: imx6-sabrelite: add OV5642 and OV5640 camera sensors

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




Hi Vladimir,


On 01/04/2017 04:25 AM, Vladimir Zapolskiy wrote:
Hi Steve,

On 01/03/2017 10:57 PM, Steve Longerbeam wrote:
Enables the OV5642 parallel-bus sensor, and the OV5640 MIPI CSI-2 sensor.
Both hang off the same i2c2 bus, so they require different (and non-
default) i2c slave addresses.

The OV5642 connects to the parallel-bus mux input port on ipu1_csi0_mux.

The OV5640 connects to the input port on the MIPI CSI-2 receiver on
mipi_csi. It is set to transmit over MIPI virtual channel 1.

Note there is a pin conflict with GPIO6. This pin functions as a power
input pin to the OV5642, but ENET uses it as the h/w workaround for
erratum ERR006687, to wake-up the ARM cores on normal RX and TX packet
done events (see 6261c4c8). So workaround 6261c4c8 is reverted here to
support the OV5642, and the "fsl,err006687-workaround-present" boolean
also must be removed. The result is that the CPUidle driver will no longer
allow entering the deep idle states on the sabrelite.
For me it sounds like a candidate of its own separate change.

Yes, I split out the two partial reverts into a separate commit
("ARM: dts: imx6qdl-sabrelite: remove erratum ERR006687
 workaround").




+
+	mipi_camera: ov5640@40 {
Please reorder device nodes by address value,

done.

  also according to ePAPR
node names should be generic, labels can be specific:

	ov5640: camera@40 {
		...
	};

	ov5642: camera@42 {
		...
	};

fixed.


+		pinctrl_ipu1_csi0: ipu1grp-csi0 {
Please rename node name to ipu1csi0grp.

done.


+
+                pinctrl_ov5640: ov5640grp {
+                        fsl,pins = <
+				MX6QDL_PAD_NANDF_D5__GPIO2_IO05 0x000b0
+				MX6QDL_PAD_NANDF_WP_B__GPIO6_IO09 0x0b0b0
+                        >;
+                };
+
Indentation issues above, please use tabs instead of spaces.

fixed.


Also please add new pin control groups preserving the alphanimerical order.

done.

Steve

--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]
  Powered by Linux