Various muxes can aggregate multiple irq lines and provide a control
register to determine the active line. Add bindings for interrupt
controller support.
Signed-off-by: Phil Reid <preid@xxxxxxxxxxxxxxxxx>
---
Documentation/devicetree/bindings/i2c/i2c-mux-pca954x.txt | 14 +++++++++++++-
1 file changed, 13 insertions(+), 1 deletion(-)
diff --git a/Documentation/devicetree/bindings/i2c/i2c-mux-pca954x.txt b/Documentation/devicetree/bindings/i2c/i2c-mux-pca954x.txt
index cf53d5f..9f7c275 100644
--- a/Documentation/devicetree/bindings/i2c/i2c-mux-pca954x.txt
+++ b/Documentation/devicetree/bindings/i2c/i2c-mux-pca954x.txt
@@ -19,7 +19,14 @@ Optional Properties:
- i2c-mux-idle-disconnect: Boolean; if defined, forces mux to disconnect all
children in idle state. This is necessary for example, if there are several
multiplexers on the bus and the devices behind them use same I2C addresses.
-
+ - interrupt-parent: Phandle for the interrupt controller that services
+ interrupts for this device.
+ - interrupts: Interrupt mapping for IRQ.
+ - interrupt-controller: Marks the device node as a interrupt controller.
+ - #interrupt-cells : Should be two.
+ - first cell is the pin number
+ - second cell is used to specify flags.
+ See also Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
Example:
@@ -29,6 +36,11 @@ Example:
#size-cells = <0>;
reg = <0x74>;
+ interrupt-parent = <&ipic>;
+ interrupts = <17 IRQ_TYPE_LEVEL_LOW>;
+ interrupt-controller;
+ #interrupt-cells=<2>;
+
i2c@2 {
#address-cells = <1>;
#size-cells = <0>;
--
1.8.3.1
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
