On Mon, Dec 26, 2016 at 02:20:28PM +0900, Jaehoon Chung wrote: > Signed-off-by: Jaehoon Chung <jh80.chung@xxxxxxxxxxx> > --- > .../devicetree/bindings/pci/exynos5433-pcie.txt | 36 ++++++++++++++++++++++ > 1 file changed, 36 insertions(+) > create mode 100644 Documentation/devicetree/bindings/pci/exynos5433-pcie.txt > > diff --git a/Documentation/devicetree/bindings/pci/exynos5433-pcie.txt b/Documentation/devicetree/bindings/pci/exynos5433-pcie.txt > new file mode 100644 > index 0000000..932a847 > --- /dev/null > +++ b/Documentation/devicetree/bindings/pci/exynos5433-pcie.txt > @@ -0,0 +1,36 @@ > +* Samsung Exynos5433 PCIe interface > + > +This PCIe host controller is based on the Synopsis Designware PCIe IP Synopsys. > +and thus inherits all the common properties defined in designware-pcie.txt. > + > +Required properties: > +- compatible: "samsung,exynos5433-pcie" > +- reg: base addresses and lengths of the pcie controller, > + the phy controller, additional register for the phy controller. You mentioned three regs but the example contains four of them. Is the config comming from snps,dw-pcie? > +- reg-names: Must be "elbi", "phy" and "dbi" for each regs Again, three here, four in example. > +- interrupt-names: Must be "intr" for legacy interrupt pin. > + > +Other common properites refer to > + Documentation/devicetree/binding/pci/designware-pcie.txt > + > +Example: > + > + pcie: pcie@15700000 { > + compatible ="samsung,exynos5433-pcie", "snps,dw-pcie"; ^ space needed > + #address-cells = <3>; > + #size-cells = <2>; > + device_type = "pci"; > + interrupts = <GIC_SPI 245 IRQ_TYPE_LEVEL_HIGH>; > + interrupt-names = "intr"; > + clocks = <&cmu_fsys CLK_PCIE>, <&cmu_fsys CLK_PCLK_PCIE_PHY>; > + clock-names = "pcie", "pcie_bus"; > + num-lanes = <1>; > + pinctrl-names = "default"; > + pinctrl-0 = <&pcie_bus>; > + reg = <0x156b0000 0x1000>, <0x15680000 0x1000>, > + <0x15700000 0x1000>, <0x0c000000 0x1000>; Indentation here looks wrong. You indented it with spaces after tabs... but not to align with line before. Beside that, fine with me: Acked-by: Krzysztof Kozlowski <krzk@xxxxxxxxxx> Best regards, Krzysztof > + reg-names = "elbi", "phy", "dbi", "config"; > + ranges = <0x81000000 0 0 0x0c001000 0 0x00010000 > + 0x82000000 0 0x0c011000 0x0c011000 0 0x3feefff>; > + status = "disabled"; > + }; > -- > 2.10.2 > -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html