Add fifo-addr property and fifo-watermark-quirk property to synopsys-dw-mshc bindings. It is intended to provide more dt interface to support SoCs specific configuration. Signed-off-by: Jun Nie <jun.nie@xxxxxxxxxx> --- Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt | 13 +++++++++++++ 1 file changed, 13 insertions(+) diff --git a/Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt b/Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt index 7fd17c3..bca30b6 100644 --- a/Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt +++ b/Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt @@ -75,6 +75,17 @@ Optional properties: * card-detect-delay: Delay in milli-seconds before detecting card after card insert event. The default value is 0. +* data-addr: Override fifo address with value provided by DT. The default FIFO reg + offset is assumed as 0x100 (version < 0x240A) and 0x200(version >= 0x240A) by + driver. If the controller does not follow this rule, please use this property + to set fifo address in device tree. + +* fifo-watermark-aligned: Data done irq is expected if data length is less than + watermark in PIO mode. But fifo watermark is requested to be aligned with data + length in some SoC so that TX/RX irq can be generated with data done irq. Add this + watermark quirk to mark this requirement and force fifo watermark setting + accordingly. + * vmmc-supply: The phandle to the regulator to use for vmmc. If this is specified we'll defer probe until we can find this regulator. @@ -102,6 +113,8 @@ board specific portions as listed below. interrupts = <0 75 0>; #address-cells = <1>; #size-cells = <0>; + data-addr = <0x200>; + fifo-watermark-aligned; resets = <&rst 20>; reset-names = "reset"; }; -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
