On Fri, Dec 02, 2016 at 09:37:02AM -0600, Nathan Sullivan wrote:
> The GPIO-based NAND controller on National Instruments 169445 hardware
> exposes a set of simple lines for the control signals.
>
> Signed-off-by: Nathan Sullivan <nathan.sullivan@xxxxxx>
> ---
> "devicetree: add vendor prefix for National Instruments" added the ni vendor prefix.
>
> This patch is needed for "MIPS: NI 169445 board support", so that GPIO NAND can work.
>
> .../bindings/gpio/ni,169445-nand-gpio.txt | 36 ++++++++++++++++++++++
> drivers/gpio/gpio-mmio.c | 1 +
> 2 files changed, 37 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/gpio/ni,169445-nand-gpio.txt
>
> diff --git a/Documentation/devicetree/bindings/gpio/ni,169445-nand-gpio.txt b/Documentation/devicetree/bindings/gpio/ni,169445-nand-gpio.txt
> new file mode 100644
> index 0000000..ca2c14f
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/gpio/ni,169445-nand-gpio.txt
> @@ -0,0 +1,36 @@
> +Bindings for the National Instruments 169445 GPIO NAND controller
> +
> +The 169445 GPIO NAND controller has two memory mapped GPIO registers, one
> +for input (the ready signal) and one for output (control signals). It is
> +intended to be used with the GPIO NAND driver.
> +
> +Required properties:
> + - compatible: should be "ni,169445-nand-gpio"
> + - reg-names: must contain
> + "dat" - data register
-names with a single entry is pointless.
> + - reg: address + size pairs describing the GPIO register sets;
> + order must correspond with the order of entries in reg-names
> + - #gpio-cells: must be set to 2. The first cell is the pin number and
> + the second cell is used to specify the gpio polarity:
> + 0 = active high
> + 1 = active low
> + - gpio-controller: Marks the device node as a gpio controller.
> +
> +Examples:
> + gpio1: nand-gpio-out@1f300010 {
gpio-controller@...
> + compatible = "ni,169445-nand-gpio";
> + reg = <0x1f300010 0x4>;
> + reg-names = "dat";
> + gpio-controller;
> + #gpio-cells = <2>;
> + ngpios = <5>;
> + };
> +
> + gpio2: nand-gpio-in@1f300014 {
ditto
> + compatible = "ni,169445-nand-gpio";
> + reg = <0x1f300014 0x4>;
> + reg-names = "dat";
> + gpio-controller;
> + #gpio-cells = <2>;
> + ngpios = <1>;
> + };
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
