On Wed, 2016-12-07 at 17:55 +0000, Luis Oliveira wrote:
> - Missspelling, comment formatation and fix a string of
> the existing code
>
Good, but after addressing below comments:
Acked-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>
> --- a/drivers/i2c/busses/i2c-designware-slave.c
> +++ b/drivers/i2c/busses/i2c-designware-slave.c
> @@ -70,8 +70,8 @@ int i2c_dw_init_slave(struct dw_i2c_dev *dev)
> /* Configure register access mode 16bit */
> dev->accessor_flags |= ACCESS_16BIT;
> } else if (reg != DW_IC_COMP_TYPE_VALUE) {
> - dev_err(dev->dev, "Unknown Synopsys component type: "
> - "0x%08x\n", reg);
> + dev_err(dev->dev,
> + "Unknown Synopsys component type: 0x%08x\n", reg);
Keep indentation like
some_call(param, param2, ...
paramX, paramY, ...);
It applies to all your new code you bring by this series.
> @@ -181,8 +181,10 @@ int i2c_dw_reg_slave(struct i2c_client *slave)
> return -EBUSY;
> if (slave->flags & I2C_CLIENT_TEN)
> return -EAFNOSUPPORT;
> - /* set slave address in the IC_SAR register,
> - * the address to which the DW_apb_i2c responds */
> + /*
> + * set slave address in the IC_SAR register,
> + * the address to which the DW_apb_i2c responds
Again, Capital letter here, dot at the end of sentence. You may fix (if
you want to) the rest of comment lines in entire driver.
> + */
>
> __i2c_dw_enable(dev, false);
> dw_writel(dev, slave->addr, DW_IC_SAR);
--
Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>
Intel Finland Oy
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
