On Monday 28 November 2016 01:12 PM, Tomi Valkeinen wrote: > On 28/11/16 07:24, Sekhar Nori wrote: >> On Friday 25 November 2016 09:07 PM, Bartosz Golaszewski wrote: >>> It has been determined that the maximum resolution supported correctly >>> by tilcdc rev1 on da850 SoCs is 800x600@60. Due to memory throughput >>> constraints we must filter out higher modes. >>> >>> Specify the max-bandwidth property for the display node for >>> da850-based boards. >>> >>> Signed-off-by: Bartosz Golaszewski <bgolaszewski@xxxxxxxxxxxx> >>> --- >>> arch/arm/boot/dts/da850.dtsi | 1 + >>> 1 file changed, 1 insertion(+) >>> >>> diff --git a/arch/arm/boot/dts/da850.dtsi b/arch/arm/boot/dts/da850.dtsi >>> index 8e30d9b..9b7c444 100644 >>> --- a/arch/arm/boot/dts/da850.dtsi >>> +++ b/arch/arm/boot/dts/da850.dtsi >>> @@ -452,6 +452,7 @@ >>> compatible = "ti,da850-tilcdc"; >>> reg = <0x213000 0x1000>; >>> interrupts = <52>; >>> + max-bandwidth = <28800000>; >> >> If this is effectively the max pixel clock that the device supports, >> then why not use the datasheet specified value of 37.5 MHz (Tc = 26.66 ns). > > There's a separate property for max-pixelclock. This one is maximum > pixels per second (which does sound almost the same), but the doc says > it's about the particular memory interface + LCDC combination. DA850 supports both mDDR and DDR2, at slightly different speeds. So memory bandwidth limitation is also board specific. This should probably move to board file. But I would like to know why using max-pixelclock is not good enough. Have experiments shown that LCDC on DA850 LCDK underflows even if pixel clock is below the datasheet recommendation? Thanks, Sekhar -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html