All four devices are only using the dwc3 controller. The actual ports are provided by dwc3's internal USB hub. The implementation on P230, P231 and Q201 seems identical: the USB VBUS supply seems to be hard-wired, while on Q200 the USB VBUS is provided by GPIOAO_5. Signed-off-by: Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx> --- arch/arm64/boot/dts/amlogic/meson-gx-p23x-q20x.dtsi | 12 ++++++++++++ arch/arm64/boot/dts/amlogic/meson-gxm-s912-q200.dts | 17 +++++++++++++++++ 2 files changed, 29 insertions(+) diff --git a/arch/arm64/boot/dts/amlogic/meson-gx-p23x-q20x.dtsi b/arch/arm64/boot/dts/amlogic/meson-gx-p23x-q20x.dtsi index 7a078be..360c91d 100644 --- a/arch/arm64/boot/dts/amlogic/meson-gx-p23x-q20x.dtsi +++ b/arch/arm64/boot/dts/amlogic/meson-gx-p23x-q20x.dtsi @@ -188,3 +188,15 @@ ðmac { status = "okay"; }; + +&usb2_phys { + status = "okay"; +}; + +&usb3_phy0 { + status = "okay"; +}; + +&usb0 { + status = "okay"; +}; diff --git a/arch/arm64/boot/dts/amlogic/meson-gxm-s912-q200.dts b/arch/arm64/boot/dts/amlogic/meson-gxm-s912-q200.dts index 5dbc660..6c28e87 100644 --- a/arch/arm64/boot/dts/amlogic/meson-gxm-s912-q200.dts +++ b/arch/arm64/boot/dts/amlogic/meson-gxm-s912-q200.dts @@ -49,6 +49,19 @@ / { compatible = "amlogic,q200", "amlogic,s912", "amlogic,meson-gxm"; model = "Amlogic Meson GXM (S912) Q200 Development Board"; + + usb_pwr: regulator-usb-pwrs { + compatible = "regulator-fixed"; + + regulator-name = "USB_PWR"; + + regulator-min-microvolt = <5000000>; + regulator-max-microvolt = <5000000>; + + /* signal name in schematic: USB_PWR_EN */ + gpio = <&gpio GPIODV_24 GPIO_ACTIVE_HIGH>; + enable-active-high; + }; }; /* Q200 has exclusive choice between internal or external PHY */ @@ -75,3 +88,7 @@ max-speed = <1000>; }; }; + +&usb3_phy0 { + phy-supply = <&usb_pwr>; +}; -- 2.10.2 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html