The old logic always enabled the TX-delay when the phy-mode was set to
PHY_INTERFACE_MODE_RGMII. There are dedicated phy-modes which tell the
PHY driver to enable the RX and/or TX delays:
- PHY_INTERFACE_MODE_RGMII should disable the RX and TX delay in the
PHY (if required, the MAC should add the delays in this case)
- PHY_INTERFACE_MODE_RGMII_ID should enable RX and TX delay in the PHY
- PHY_INTERFACE_MODE_RGMII_TXID should enable the TX delay in the PHY
- PHY_INTERFACE_MODE_RGMII_RXID should enable the RX delay in the PHY
(currently not supported by RTL8211F)
With this patch we enable the TX delay for PHY_INTERFACE_MODE_RGMII_ID
and PHY_INTERFACE_MODE_RGMII_TXID.
Additionally we now explicity disable the TX-delay, which seems to be
enabled automatically after a hard-reset of the PHY (by triggering it's
reset pin) to get a consistent state (as defined by the phy-mode).
This fixes a compatibility problem with some SoCs where the TX-delay was
also added by the MAC. With the TX-delay being applied twice the TX
clock was off and TX traffic was broken or very slow (<10Mbit/s) on
1000Mbit/s links.
Signed-off-by: Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx>
---
drivers/net/phy/realtek.c | 20 ++++++++++++--------
1 file changed, 12 insertions(+), 8 deletions(-)
diff --git a/drivers/net/phy/realtek.c b/drivers/net/phy/realtek.c
index aadd6e9..9cbe645 100644
--- a/drivers/net/phy/realtek.c
+++ b/drivers/net/phy/realtek.c
@@ -102,15 +102,19 @@ static int rtl8211f_config_init(struct phy_device *phydev)
if (ret < 0)
return ret;
- if (phydev->interface == PHY_INTERFACE_MODE_RGMII) {
- /* enable TXDLY */
- phy_write(phydev, RTL8211F_PAGE_SELECT, 0xd08);
- reg = phy_read(phydev, 0x11);
+ phy_write(phydev, RTL8211F_PAGE_SELECT, 0xd08);
+ reg = phy_read(phydev, 0x11);
+
+ /* enable TX-delay for rgmii-id and rgmii-txid, otherwise disable it */
+ if (phydev->interface == PHY_INTERFACE_MODE_RGMII_ID ||
+ phydev->interface == PHY_INTERFACE_MODE_RGMII_TXID)
reg |= RTL8211F_TX_DELAY;
- phy_write(phydev, 0x11, reg);
- /* restore to default page 0 */
- phy_write(phydev, RTL8211F_PAGE_SELECT, 0x0);
- }
+ else
+ reg &= ~RTL8211F_TX_DELAY;
+
+ phy_write(phydev, 0x11, reg);
+ /* restore to default page 0 */
+ phy_write(phydev, RTL8211F_PAGE_SELECT, 0x0);
return 0;
}
--
2.10.2
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
