Add the mshc_2 node for supporting T-flash. And it needs to add the "mshc*" aliases. Because dwmmc driver should be assigned to "ctrl_id" after parsing to "mshc". If there is no aliases for mshc, then it might be set to the wrong capabilities. Signed-off-by: Jaehoon Chung <jh80.chung@xxxxxxxxxxx> --- arch/arm64/boot/dts/exynos/exynos5433-tm2.dts | 19 +++++++++++++++++++ 1 file changed, 19 insertions(+) diff --git a/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts b/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts index 9ea3f32..75dab01 100644 --- a/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts +++ b/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts @@ -42,6 +42,8 @@ spi2 = &spi_2; spi3 = &spi_3; spi4 = &spi_4; + mshc0 = &mshc_0; + mshc2 = &mshc_2; }; chosen { @@ -661,6 +663,23 @@ assigned-clock-rates = <800000000>; }; +&mshc_2 { + status = "okay"; + num-slots = <1>; + cap-sd-highspeed; + disable-wp; + cd-gpios = <&gpa2 4 0>; + cd-inverted; + card-detect-delay = <200>; + samsung,dw-mshc-ciu-div = <3>; + samsung,dw-mshc-sdr-timing = <0 4>; + samsung,dw-mshc-ddr-timing = <0 2>; + fifo-depth = <0x80>; + pinctrl-names = "default"; + pinctrl-0 = <&sd2_clk &sd2_cmd &sd2_bus1 &sd2_bus4>; + bus-width = <4>; +}; + &pinctrl_alive { pinctrl-names = "default"; pinctrl-0 = <&initial_alive>; -- 2.10.1 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html