This patchset allows more configs to make use of movable nodes. When CONFIG_MOVABLE_NODE is selected, there are two ways to introduce such nodes into the system: 1. Discover movable nodes at boot. Currently this is only possible on x86, but we will enable configs supporting fdt to do the same. 2. Hotplug and online all of a node's memory using online_movable. This is already possible on any config supporting memory hotplug, not just x86, but the Kconfig doesn't say so. We will fix that. We'll also remove some cruft on power which would prevent (2). /* changelog */ v7: * Fix error when !CONFIG_HAVE_MEMBLOCK, found by the kbuild test robot. * Remove the prefix of "linux,hotpluggable". Document the property's purpose. v6: * http://lkml.kernel.org/r/1478562276-25539-1-git-send-email-arbab@xxxxxxxxxxxxxxxxxx * Add a patch enabling the fdt to describe hotpluggable memory. v5: * http://lkml.kernel.org/r/1477339089-5455-1-git-send-email-arbab@xxxxxxxxxxxxxxxxxx * Drop the patches which recognize the "status" property of dt memory nodes. Firmware can set the size of "linux,usable-memory" to zero instead. v4: * http://lkml.kernel.org/r/1475778995-1420-1-git-send-email-arbab@xxxxxxxxxxxxxxxxxx * Rename of_fdt_is_available() to of_fdt_device_is_available(). Rename of_flat_dt_is_available() to of_flat_dt_device_is_available(). * Instead of restoring top-down allocation, ensure it never goes bottom-up in the first place, by making movable_node arch-specific. * Use MEMORY_HOTPLUG instead of PPC64 in the mm/Kconfig patch. v3: * http://lkml.kernel.org/r/1474828616-16608-1-git-send-email-arbab@xxxxxxxxxxxxxxxxxx * Use Rob Herring's suggestions to improve the node availability check. * More verbose commit log in the patch enabling CONFIG_MOVABLE_NODE. * Add a patch to restore top-down allocation the way x86 does. v2: * http://lkml.kernel.org/r/1473883618-14998-1-git-send-email-arbab@xxxxxxxxxxxxxxxxxx * Use the "status" property of standard dt memory nodes instead of introducing a new "ibm,hotplug-aperture" compatible id. * Remove the patch which explicitly creates a memoryless node. This set no longer has any bearing on whether the pgdat is created at boot or at the time of memory addition. v1: * http://lkml.kernel.org/r/1470680843-28702-1-git-send-email-arbab@xxxxxxxxxxxxxxxxxx Reza Arbab (5): powerpc/mm: allow memory hotplug into a memoryless node mm: remove x86-only restriction of movable_node mm: enable CONFIG_MOVABLE_NODE on non-x86 arches of/fdt: mark hotpluggable memory dt: add documentation of "hotpluggable" memory property Documentation/devicetree/booting-without-of.txt | 7 +++++++ Documentation/kernel-parameters.txt | 2 +- arch/powerpc/mm/numa.c | 13 +------------ arch/x86/kernel/setup.c | 24 ++++++++++++++++++++++++ drivers/of/fdt.c | 19 +++++++++++++++++++ include/linux/of_fdt.h | 1 + mm/Kconfig | 2 +- mm/memory_hotplug.c | 20 -------------------- 8 files changed, 54 insertions(+), 34 deletions(-) -- 1.8.3.1 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
