Hi Romain,
You was too fast I didn't have time to commnent about Baruch suggestion.
On mer., nov. 09 2016, Romain Perier <romain.perier@xxxxxxxxxxxxxxxxxx> wrote:
> The Armada 3700 has two I2C controllers that is compliant with the I2C
> Bus Specificiation 2.1, supports multi-master and different bus speed:
> Standard mode (up to 100 KHz), Fast mode (up to 400 KHz),
> High speed mode (up to 3.4 Mhz).
>
> This IP block has a lot of similarity with the PXA, except some register
> offsets and bitfield. This commits adds a basic support for this I2C
> unit.
>
> Signed-off-by: Romain Perier <romain.perier@xxxxxxxxxxxxxxxxxx>
> Tested-by: Gregory CLEMENT <gregory.clement@xxxxxxxxxxxxxxxxxx>
> ---
>
> Changes in v3:
> - Replaced the type of hm_mask and fm_mask by unsigned int,
> instead of unsigned long.
[...]
> #define ISR_RWM (1 << 0) /* read/write mode */
> @@ -193,6 +204,8 @@ struct pxa_i2c {
> unsigned char master_code;
> unsigned long rate;
> bool highmode_enter;
> + unsigned int fm_mask;
> + unsigned int hs_mask;
These masks are used with writel and readl which use an u32. So the
better is to use this type.
Gregory
> };
>
> #define _IBMR(i2c) ((i2c)->reg_ibmr)
> @@ -503,8 +516,8 @@ static void i2c_pxa_reset(struct pxa_i2c *i2c)
> writel(i2c->slave_addr, _ISAR(i2c));
>
> /* set control register values */
> - writel(I2C_ICR_INIT | (i2c->fast_mode ? ICR_FM : 0), _ICR(i2c));
> - writel(readl(_ICR(i2c)) | (i2c->high_mode ? ICR_HS : 0), _ICR(i2c));
> + writel(I2C_ICR_INIT | (i2c->fast_mode ? i2c->fm_mask : 0), _ICR(i2c));
> + writel(readl(_ICR(i2c)) | (i2c->high_mode ? i2c->hs_mask : 0), _ICR(i2c));
>
--
Gregory Clement, Free Electrons
Kernel, drivers, real-time and embedded Linux
development, consulting, training and support.
http://free-electrons.com
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
