These can be used to fill information needed to configure
master controller registers.
Signed-off-by: Sourav Poddar <sourav.poddar@xxxxxx>
---
v1->v2:
instead of a u8 *val, use a struct (slave_info) already defined
in the first patch of the series. This will allow us to add more
parameters into the struct.
drivers/mtd/devices/m25p80.c | 18 ++++++++++++++++++
1 files changed, 18 insertions(+), 0 deletions(-)
diff --git a/drivers/mtd/devices/m25p80.c b/drivers/mtd/devices/m25p80.c
index 7dc2c14..b90c7e5 100644
--- a/drivers/mtd/devices/m25p80.c
+++ b/drivers/mtd/devices/m25p80.c
@@ -490,6 +490,24 @@ static inline int m25p80_dummy_cycles_read(struct m25p *flash)
}
/*
+ * This API can be used to transfer flash information to
+ * SPI controller which needs some of its registers to get
+ * configured on flash information.
+ */
+static void m25p80_fill_flash_information(struct m25p *flash)
+{
+ struct spi_device *spi = flash->spi;
+ struct spi_master *master = spi->master;
+
+ spi->info.read_opcode = flash->read_opcode;
+ spi->info.program_opcode = flash->program_opcode;
+ spi->info.addr_width = flash->addr_width;
+ spi->info.dummy_cycles = m25p80_dummy_cycles_read(flash);
+
+ master->configure_from_slave(flash->spi);
+}
+
+/*
* Read an address range from the flash chip. The address range
* may be any size provided it is within the physical boundaries.
*/
--
1.7.1
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
