On Wed 26 Oct 16:32 PDT 2016, Michael Scott wrote: > Initial pinctrl driver for QCOM msm8994 platforms. > > In order to continue the initial board support for QCOM msm8994/msm8992 > presented in patches from Jeremy McNicoll <jeremymc@xxxxxxxxxx>, let's put > a proper pinctrl driver in place. > > Currently, the DT for these platforms uses the msm8x74 pinctrl driver to enable > basic UART. Beyond the first few pins the rest are different enough to justify > it's own driver. > > Note: This driver is also be used by QCOM's msm8992 platform as it's TLM block > is the same. > I'm not up to speed on the 8992/8994 story, but please add a "qcom,msm8992-pinctrl" compatible to the list as well. > - Initial formatting and style was taken from the msm8x74 pinctrl driver added > by Björn Andersson <bjorn.andersson@xxxxxxxxxx> > - Data was then adjusted per QCOM MSM8994 documentation for Top Level Multiplexing I think this is good enough. It looks reasonable and you based it on the data sheet. Any fixes to the tables can be added incrementally. > - Bindings documentation was based on qcom,msm8996-pinctrl.txt by > Joonwoo Park <joonwoop@xxxxxxxxxxxxxx> and then modified for msm8994 content > > Signed-off-by: Michael Scott <michael.scott@xxxxxxxxxx> Please add the compatible and you have my Acked-by: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx> Regards, Bjorn -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
