Re: [PATCH] gpio: mcp23s08: Add option to configure pullups.

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




On Fri, Oct 21, 2016 at 5:00 PM, Enric Balletbo i Serra
<enric.balletbo@xxxxxxxxxxxxx> wrote:

> Default is without pullups, but if property is specified in DT and the bit
> is set, set a pullup on GPIO-n.
>
> Signed-off-by: Enric Balletbo i Serra <enric.balletbo@xxxxxxxxxxxxx>

I don't generally like this.

In device tree it is the consumer that specifies how the line is used,
not the producer (gpiochip).

We currently only specify polarity, open drain and open source
for consumers though.

And the entire pin control system came into being *exactly* because
Grant didn't like me adding these things to the GPIO drivers.

So how many other things does the MCP support? Drive strength?
Schmitt trigger? Is there a datasheet?

Yours,
Linus Walleij
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]
  Powered by Linux