On Fri, Oct 21, 2016 at 03:42:50PM -0700, Michael Scott wrote: > Initial pinctrl driver for QCOM msm8994 platforms. > > In order to continue the initial board support for QCOM msm8994/msm8992 > presented in patches from Jeremy McNicoll <jeremymc@xxxxxxxxxx>, let's put > a proper pinctrl driver in place. > > Currently, the DT for these platforms uses the msm8x74 pinctrl driver to enable > basic UART. Beyond the first few pins the rest are different enough to justify > it's own driver. > > Note: This driver is also be used by QCOM's msm8992 platform as it's TLM block > is the same. > > - Initial formatting and style was taken from the msm8x74 pinctrl driver added > by Björn Andersson <bjorn.andersson@xxxxxxxxxx> > - Data was then adjusted per QCOM MSM8994 documentation for Top Level Multiplexing > - Bindings documentation was based on qcom,msm8996-pinctrl.txt by > Joonwoo Park <joonwoop@xxxxxxxxxxxxxx> and then modified for msm8994 content > > Signed-off-by: Michael Scott <michael.scott@xxxxxxxxxx> > --- > .../bindings/pinctrl/qcom,msm8994-pinctrl.txt | 175 +++ > drivers/pinctrl/qcom/Kconfig | 9 + > drivers/pinctrl/qcom/Makefile | 1 + > drivers/pinctrl/qcom/pinctrl-msm8994.c | 1402 ++++++++++++++++++++ > 4 files changed, 1587 insertions(+) > create mode 100644 Documentation/devicetree/bindings/pinctrl/qcom,msm8994-pinctrl.txt > create mode 100644 drivers/pinctrl/qcom/pinctrl-msm8994.c > This works fine on my msm8992 which currently only supports basic serial. Having already compared it to downstream it looks like things line up pretty good. (from a msm8992 perspective) Reviewed-by: Jeremy McNicoll <jeremymc@xxxxxxxxxx> -jeremy -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html