[PATCH v2 10/10] bindings: gpio-sx150x: Document new bindings

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




This patch documents the conversion of various platform data options
that used to be availible to SX150x driver to device tree/OF form.

Signed-off-by: Andrey Smirnov <andrew.smirnov@xxxxxxxxx>
---
 .../devicetree/bindings/gpio/gpio-sx150x.txt       | 29 ++++++++++++++++++++++
 1 file changed, 29 insertions(+)

diff --git a/Documentation/devicetree/bindings/gpio/gpio-sx150x.txt b/Documentation/devicetree/bindings/gpio/gpio-sx150x.txt
index c809acb..e96b554 100644
--- a/Documentation/devicetree/bindings/gpio/gpio-sx150x.txt
+++ b/Documentation/devicetree/bindings/gpio/gpio-sx150x.txt
@@ -26,6 +26,35 @@ The GPIO expander can optionally be used as an interrupt controller, in
 which case it uses the default two cell specifier as described in
 Documentation/devicetree/bindings/interrupt-controller/interrupts.txt.
 
+Optional properties:
+
+- semtech,io-polarity: A bit-mask which enables polarity inversion for
+  		       each IO line in the expander. Setting the bit
+  		       at position n inverts the polarity of that IO
+  		       line, while clearing it results in normal
+  		       polarity. For chips with fewer than 16 IO pins,
+  		       high-end bits are ignored.
+
+- semtech,io-pullup:
+- semtech,io-pulldown: A bit-mask which enables-or disables the
+  		       pull-up (pull-down) resistor for each IO line
+  		       in the expander. Setting the bit at position n
+  		       will enable the pull-down for the IO at the
+  		       corresponding offset.  For chips with fewer
+  		       than 16 IO pins, high-end bits are ignored.
+
+- semtech,reset-during-probe: Boolean, if true, the driver will
+  			      trigger a full reset of the chip at the
+  			      beginning of the probe in order to place
+  			      it in a known state.
+
+- semtech,oscio-is-gpo: Boolean, if set to true, the driver will
+  			configure OSCIO as a GPO instead of as an
+  			oscillator, increasing the size of the GP(I)O
+  			pool created by this expander by one.  The
+  			output-only GPO pin will be added at the end
+  			of the block.
+
 Example:
 
 	i2c_gpio_expander@20{
-- 
2.5.5

--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]
  Powered by Linux