When the broken-highspeed property is set the sdhci driver will not go into highspeed mode even if the controller and card appear to otherwise support highspeed mode. This is useful in cases where the controller and card support highspeed, but the board configuration or some other issue make highspeed impossible. For example, we send the SDIO lines through a fpga so we need the data to change on the falling edge of the clock or there will be issues with hold time. Signed-off-by: Zach Brown <zach.brown@xxxxxx> Acked-by: Adrian Hunter <adrian.hunter@xxxxxxxxx> --- drivers/mmc/host/sdhci.c | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-) diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c index 1e25b01..4ec44fd 100644 --- a/drivers/mmc/host/sdhci.c +++ b/drivers/mmc/host/sdhci.c @@ -22,6 +22,7 @@ #include <linux/scatterlist.h> #include <linux/regulator/consumer.h> #include <linux/pm_runtime.h> +#include <linux/of.h> #include <linux/leds.h> @@ -3269,7 +3270,8 @@ int sdhci_setup_host(struct sdhci_host *host) if (host->quirks2 & SDHCI_QUIRK2_HOST_NO_CMD23) mmc->caps &= ~MMC_CAP_CMD23; - if (host->caps & SDHCI_CAN_DO_HISPD) + if ((host->caps & SDHCI_CAN_DO_HISPD) && + !(of_property_read_bool(mmc_dev(mmc)->of_node, "broken-highspeed"))) mmc->caps |= MMC_CAP_SD_HIGHSPEED | MMC_CAP_MMC_HIGHSPEED; if ((host->quirks & SDHCI_QUIRK_BROKEN_CARD_DETECTION) && -- 2.7.4 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
