On Fri, Oct 07, 2016 at 06:42:54PM +0200, ahaslam@xxxxxxxxxxxx wrote: > From: Axel Haslam <ahaslam@xxxxxxxxxxxx> > > This patch documents the device tree bindings required for > the ohci controller found in TI da8xx family of SoC's > > Signed-off-by: Axel Haslam <ahaslam@xxxxxxxxxxxx> > --- > .../devicetree/bindings/usb/ohci-da8xx.txt | 32 ++++++++++++++++++++++ > 1 file changed, 32 insertions(+) > create mode 100644 Documentation/devicetree/bindings/usb/ohci-da8xx.txt > > diff --git a/Documentation/devicetree/bindings/usb/ohci-da8xx.txt b/Documentation/devicetree/bindings/usb/ohci-da8xx.txt > new file mode 100644 > index 0000000..e954ce5 > --- /dev/null > +++ b/Documentation/devicetree/bindings/usb/ohci-da8xx.txt > @@ -0,0 +1,32 @@ > +DA8XX USB OHCI controller > + > +Required properties: > + > + - compatible: Should be "ti,da830-ohci" > + - reg: Should contain one register range i.e. start and length > + - interrupts: Description of the interrupt line > + - phys: Phandle for the PHY device > + - phy-names: Should be "usb-phy" > + > +Optional properties: > + - vbus-gpio: If present, specifies a gpio that needs to be vbus-gpios > + activated for the bus to be powered. > + - oci-gpio: If present, specifies a gpio that needs to be oci-gpios > + activated for the overcurrent detection. > + - power_on_delay: Power On to Power Good time - in ms. power-on-delay-ms > + > +Example for omap138-lck: > + > +usb_phy: usb-phy { > + compatible = "ti,da830-usb-phy"; > + #phy-cells = <1>; > + status = "disabled"; > +}; > +usb11: usb11@0225000 { > + compatible = "ti,da830-ohci"; > + reg = <0x225000 0x1000>; > + interrupts = <59>; > + phys = <&usb_phy 1>; > + phy-names = "usb-phy"; > + status = "disabled"; > +}; > -- > 2.7.1 > -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html