Hi, This is v5 version of the patch series with addition of HS400 patches in this. These are tested on internal msm8996 & db410c HW. Though there is a discussion going on w.r.t. clk-rates DT entry[6] but I would like to get below patches reviewed, since these patches should not be functionally impacted. Changes from v4 -> v5 :- 1. Added HS400 sdhci-msm controller specific changes:- (Patch 10, 11, 12) 2. Addressed comment from Adrian on Patch 07 @[3]. 3. Addressed comment from Arnd on Patch 03, to directly add clk_table into sdhci_msm_host. [4] 4. Addressed comment from Bjorn to not enforce having clk-rates property in DT for older targets based on discussion at [5] 5. Retained Acks from Adrian on patches (01 & 02 & 06) where there were no changes made while addressing above comments. Older history:- This is v4 version of the patch series. Patches 01, 02, 05 & 06 were Acked-by Adrian. Changes from v3 -> v4 :- 1. Addressed comments from Adrian on Patch 03, 07, 08. 2. Addressed comments from Bjorn on Patch 03. 3. Added clk-rate support for sdhc DT nodes to all MSM platforms. in Pacth 04. 4. Rebased on next branch of Ulf. Changes from v2 -> v3 :- 1. Addded Patch 01 based on Bjorn comment[2] - This fixes/unrolls the poor coding style of read/writes of registers from base sdhci-msm driver. 2. Fixed/unrolled poor style of reads/writes of registers in Patch 02, based on Bjorn comment[2]. Also changed name of flag from use_updated_dll_reset -> use_14lpp_dll_reset. Changes from v1->v2 :- 1. Removed patch 06 & 08 from v1 patch series[1] (which were introducing unnecessary quirks). Instead have implemented __sdhci_msm_set_clock version of sdhci_set_clock in sdhci_msm driver itself in patch 07 of this patch series. 2. Enabled extra quirk (SDHCI_QUIRK2_PRESET_VALUE_BROKEN) in patch 05 of this patch series. Description of patches :- This patchset adds clk-rates & other required changes to upstream sdhci-msm driver from codeaurora tree. It has been tested on a db410c Dragonboard and msm8996 based platform. Patch 0002 - Adds updated dll sequence for newer controllers which has minor_version >= 0x42. This is required for msm8996. MSM controller HW recommendation is to use the base MCI clock and directly control this MCI clock at GCC in order to change the clk-rate. Patches 03-07 bring in required change for this to sdhci-msm and DT. MSM controller would require 2x clock rate from source for DDR bus speed modes. Patch 08 adds this support. Patch 09 - adds DDR support in DT for sdhc1 of msm8916. [1]:- http://www.spinics.net/lists/linux-mmc/msg38467.html [2]:- http://www.spinics.net/lists/linux-mmc/msg38578.html [3]:- https://patchwork.kernel.org/patch/9289345/ [4]:- https://www.spinics.net/lists/linux-mmc/msg39107.html [5]:- http://www.spinics.net/lists/linux-mmc/msg38749.html [6]:- https://patchwork.kernel.org/patch/9297381/ Ritesh Harjani (9): mmc: sdhci-msm: Change poor style writel/readl of registers mmc: sdhci-msm: add pltfm_data support to get clk-rates from DT ARM: dts: qcom: Add clk-rates to sdhc1 & sdhc2 mmc: sdhci-msm: Add get_min_clock() and get_max_clock() callback mmc: sdhci-msm: Enable few quirks mmc: sdhci-msm: Implement set_clock callback for sdhci-msm mmc: sdhci-msm: Add clock changes for DDR mode. arm64: dts: qcom: msm8916: Add ddr support to sdhc1 sdhci: sdhci-msm: update dll configuration Venkat Gopalakrishnan (3): mmc: sdhci-msm: Update DLL reset sequence mmc: sdhci-msm: Add HS400 platform support mmc: sdhci-msm: Add calibration tuning for CDCLP533 circuit .../devicetree/bindings/mmc/sdhci-msm.txt | 1 + arch/arm/boot/dts/qcom-apq8084.dtsi | 4 + arch/arm/boot/dts/qcom-msm8974.dtsi | 4 + arch/arm64/boot/dts/qcom/msm8916.dtsi | 5 + arch/arm64/boot/dts/qcom/msm8996.dtsi | 2 + drivers/mmc/host/sdhci-msm.c | 721 ++++++++++++++++++++- 6 files changed, 703 insertions(+), 34 deletions(-) -- The Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, a Linux Foundation Collaborative Project. -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
