The Sharp 15" LQ150X1LG11 panel is an XGA TFT LCD panel.
Signed-off-by: Peter Rosin <peda@xxxxxxxxxx>
---
.../bindings/display/panel/sharp,lq150x1lg11.txt | 36 ++++++++++++++++++++++
1 file changed, 36 insertions(+)
create mode 100644 Documentation/devicetree/bindings/display/panel/sharp,lq150x1lg11.txt
diff --git a/Documentation/devicetree/bindings/display/panel/sharp,lq150x1lg11.txt b/Documentation/devicetree/bindings/display/panel/sharp,lq150x1lg11.txt
new file mode 100644
index 000000000000..0f57c3143506
--- /dev/null
+++ b/Documentation/devicetree/bindings/display/panel/sharp,lq150x1lg11.txt
@@ -0,0 +1,36 @@
+Sharp 15" LQ150X1LG11 XGA TFT LCD panel
+
+Required properties:
+- compatible: should be "sharp,lq150x1lg11"
+- power-supply: regulator to provide the VCC supply voltage (3.3 volts)
+
+Optional properties:
+- backlight: phandle of the backlight device
+- rlud-gpios: a single GPIO for the RL/UD (rotate 180 degrees) pin.
+- sellvds-gpios: a single GPIO for the SELLVDS pin.
+
+If rlud-gpios and/or sellvds-gpios are not specified, the RL/UD and/or SELLVDS
+pins are assumed to be handled appropriately by the hardware.
+
+Example:
+
+ backlight: backlight {
+ compatible = "pwm-backlight";
+ pwms = <&pwm 0 100000>; /* VBR */
+
+ brightness-levels = <0 20 40 60 80 100>;
+ default-brightness-level = <2>;
+
+ power-supply = <&vdd_12v_reg>; /* VDD */
+ enable-gpios = <&gpio 42 GPIO_ACTIVE_HIGH>; /* XSTABY */
+ };
+
+ panel {
+ compatible = "sharp,lq150x1lg11";
+
+ power-supply = <&vcc_3v3_reg>; /* VCC */
+
+ backlight = <&backlight>;
+ rlud-gpios = <&gpio 17 GPIO_ACTIVE_HIGH>; /* RL/UD */
+ sellvds-gpios = <&gpio 18 GPIO_ACTIVE_HIGH>; /* SELLVDS */
+ };
--
2.1.4
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
