On Wed, Sep 28, 2016 at 01:30:17AM +0200, Maciej S. Szmigiero wrote: > On 20.09.2016 05:36, Peter Chen wrote: > > Hi all, > > > > This is a follow-up for my last power sequence framework patch set [1]. > > According to Rob Herring and Ulf Hansson's comments[2]. The kinds of > > power sequence instances will be added at postcore_initcall, the match > > criteria is compatible string first, if the compatible string is not > > matched between dts and library, it will try to use generic power sequence. > > > > The host driver just needs to call of_pwrseq_on/of_pwrseq_off > > if only one power sequence instance is needed, for more power sequences > > are used, using of_pwrseq_on_list/of_pwrseq_off_list instead (eg, USB hub driver). > > > > In future, if there are special power sequence requirements, the special > > power sequence library can be created. > > > > This patch set is tested on i.mx6 sabresx evk using a dts change, I use > > two hot-plug devices to simulate this use case, the related binding > > change is updated at patch [1/6], The udoo board changes were tested > > using my last power sequence patch set.[3] > > > > Except for hard-wired MMC and USB devices, I find the USB ULPI PHY also > > need to power on itself before it can be found by ULPI bus. > > > > [1] http://www.spinics.net/lists/linux-usb/msg142755.html > > [2] http://www.spinics.net/lists/linux-usb/msg143106.html > > [3] http://www.spinics.net/lists/linux-usb/msg142815.html > > Just tested this patch set on UDOO board again to make sure that it still > works after all changes done since it was last tested there and can confirm > that it does work correctly. > Thanks, Maciej. -- Best Regards, Peter Chen -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html