> index 0000000..7ba3855
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/net/mscc-phy-vsc8531.txt
> @@ -0,0 +1,61 @@
> +* Microsemi - vsc8531 Giga bit ethernet phy
> +
> +Required properties:
> +- compatible : Should contain phy id as "ethernet-phy-idAAAA.BBBB"
> + If the phy's identifier is known then the list may contain an entry
> + of the form: "ethernet-phy-idAAAA.BBBB" where
> + AAAA - The value of the 16 bit Phy Identifier 1 register as
> + 4 hex digits. This is the chip vendor OUI bits 3:18
> + BBBB - The value of the 16 bit Phy Identifier 2 register as
> + 4 hex digits. This is the chip vendor OUI bits 19:24,
> + followed by 10 bits of a vendor specific ID.
> +- reg : The ID number for the phy, usually a small integer
Please don't copy phy.txt. Just refer to it. Use text like:
The PHY device uses the binding described in
Documentation/devicetree/bindings/net/phy.txt
It may additionally have the following properties
> +Optional properties:
> +- vsc8531,edge-rate : Edge rate sets the drive strength of the MAC
> + interface output signals. Changing the drive
> + strength will affect the edge rate of the output
> + signal.
Are we specifying a rate or a strength? It is called edge-rate, so it
expect it to be a rate, mV/pS or something similar.
Andrew
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
