Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx> writes: > Newer Amlogic platforms (Meson 8b and GXBB) use a slightly different > register layout for their Infrared Remoete Controller. The decoder mode > is now configured in another register. Without the changes to the > meson-ir driver we are simply getting incorrect "durations" reported > from the hardware (because the hardware is not in time measurement aka > software decode mode). > > This problem was also noticed by some people trying to use this on an > ODROID-C1 and ODROID-C2 - the workaround there (probably because the > datasheets were not publicy available yet at that time) was to switch > to ir_raw_event_store_edge (which leaves it up to the kernel to measure > the duration of a pulse). See [0] and [1] for the corresponding > patches. > > Changes in v5: > - changed pin function and group names to remote_input_ao so they match > with the datasheet > > Tested-by: Neil Armstrong <narmstrong@xxxxxxxxxxxx> Thanks for the respin. I'll take the driver and DT/bindings through the arm-soc tree and Linus has taken the pinctrl patch. Kevin -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
