On Sat, Aug 13, 2016 at 05:14:34AM +0200, Sebastian Reichel wrote:
> ---
> .../devicetree/bindings/net/nokia-bluetooth.txt | 43 ++++++++++++++++++++++
> 1 file changed, 43 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/net/nokia-bluetooth.txt
>
> diff --git a/Documentation/devicetree/bindings/net/nokia-bluetooth.txt b/Documentation/devicetree/bindings/net/nokia-bluetooth.txt
> new file mode 100644
> index 000000000000..a0fceabb4cce
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/net/nokia-bluetooth.txt
> @@ -0,0 +1,43 @@
> +Nokia bluetooth UART devices
> +------
> +
> +Some vendors have custom versions of their chips, that can be found in Nokia
> +devices. These chips are controlled differently, than the non-Nokia version,
> +so a different binding is required. All chips listed here implement the Nokia
> +H4+ protocol.
> +
> +Required properties:
> +
> + - compatible: should be one of the following:
> + * "nokia,brcm,bcm2048"
> + * "nokia,ti,wl1271-bluetooth"
Perhaps these should be 2 separate strings. Something like
'"nokia,n900-bt", "brcm,bcm2048"'. However, if they are in no way
compatible with the default version from the vendors, then just a single
string is fine, but it doesn't need to be aligned to the vendor
compatible string. So just "nokia,n900-bcm2048" or similar is fine.
> + - reset-gpios: Should specify the gpio for bluetooth reset
> + - host-wakeup-gpios: Should specify the gpio for host wakeup
Should be interrupt instead?
> + - bluetooth-wakeup-gpios: Should specify the gpio for bluetooth wakeup
State direction and active state for gpios.
> + - clock-names: Should be "sysclk"
> + - clocks: Should contain a clock phandle for system clock
> +
> +Example:
> +
> +/ {
> + /* controlled (enabled/disabled) directly by wl1271 */
> + vctcxo: vctcxo {
> + compatible = "fixed-clock";
> + #clock-cells = <0>;
> + clock-frequency = <38400000>;
> + };
> +};
> +
> +&uart2 {
I want to see a common serial device binding doc before accepting any
device bindings. It's not going to say much initially other than devices
are child nodes of uarts. Perhaps something on baudrate settings.
> + bluetooth {
> + compatible = "nokia,ti,wl1271-bluetooth";
> +
> + reset-gpios = <&gpio1 26 GPIO_ACTIVE_HIGH>; /* 26 */
> + host-wakeup-gpios = <&gpio4 5 GPIO_ACTIVE_HIGH>; /* 101 */
> + bluetooth-wakeup-gpios = <&gpio2 5 GPIO_ACTIVE_HIGH>; /* 37 */
> +
> + clocks = <&vctcxo>;
> + clock-names = "sysclk";
> + };
> +
> +};
> --
> 2.8.1
>
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
