Re: [PATCH v2 1/2] gpio: dt-bindings: add brcm,bcm6345-gpio bindings

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




All devicetree binding patches must be sent to the devicetree@xxxxxxxxxxxxxxx
mailing list so include them on subsequent posts of this patch.

On Wed, Aug 3, 2016 at 2:05 PM, Álvaro Fernández Rojas
<noltari@xxxxxxxxx> wrote:

> This patch adds the device tree bindings for the Broadcom's BCM6345
> memory-mapped GPIO controllers.
>
> The gpios will be supported by gpio-mmio code of the
> GPIO generic library.
>
> Signed-off-by: Álvaro Fernández Rojas <noltari@xxxxxxxxx>
> ---
>  v2: add improvements suggested by Jonas Gorski:
>   - use native-endian instead of big-endian.

What is this? Does it come from some other existing binding?
I was feeling native endian is the default unless LE or BE is
explicitly specified...

> +Required properties:
> +       - compatible: should be "brcm,bcm6345-gpio"
> +       - reg-names: must contain
> +               "dat" - data register
> +               "dirout" - direction (output) register

I don't like this and don't understand why you can't just cover
all GPIO registers with a single reg property.

> +       - reg: address + size pairs describing the GPIO register sets;
> +               order must correspond with the order of entries in reg-names
> +       - #gpio-cells: must be set to 2. The first cell is the pin number and
> +                       the second cell is used to specify the gpio polarity:
> +                       0 = active high
> +                       1 = active low
> +       - gpio-controller: Marks the device node as a gpio controller.

Reference the standard bindings in gpio.txt for cells and controller.

> +Optional properties:
> +       - native-endian: use native endian memory.

That is weird. Explain why this is needed.

> +       - BCM6345:
> +       gpio: gpio-controller@fffe0406 {
> +               compatible = "brcm,bcm6345-gpio";
> +               reg-names = "dirout", "dat";
> +               reg = <0xfffe0406 2>, <0xfffe040a 2>;

Also I do not understand this at all. Why pick out two 16bit registers?
Surely the rest of the registers at 0xfffe0400 must be GPIO registers
as well? Are they not?

If they are, cover them all with a single reg property.

If they are not all GPIO registers, use MFD syscon for this and access
the constituent parts through that.

Yours,
Linus Walleij
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]
  Powered by Linux