On Fri, Aug 05, 2016 at 07:44:18PM +0530, Sekhar Nori wrote: > On Thursday 04 August 2016 08:13 PM, Karl Beldan wrote: > > The LCDK is the successor to the late Hawkboard and has the same machine > > number. > > Among the differences are the flash (16bits vs 8bits) and some pins > > (MMC, LEDs, buttons, some external connectors), however the main > > components remain the same (eth. PHY, Audio Codec, Video decoder and > > DAC) except for the main PMIC, different and hard-wired on the LCDK (the > > LDOs and DCDCs are always ON). > > A DT-only boot with this addition gives functional uart, reboot via > > watchdog, rtc, ethernet and MMC (I added the CD gpio for the MMC > > although davinci_mmc doesn't call yet the mmc core OF facilities). > > > > Signed-off-by: Karl Beldan <kbeldan@xxxxxxxxxxxx> > > C6748 is a pin-compatible DSP-only part which does not run Linux. The > OMAP-L138 and C6748 LCDKs are physically different boards. So, I would > just stick with subject line ".. for the OMAP-L138 LCDK board" > That was my understanding but LCDK stands for L138-C6748-Dev-Kit right ? Anyways, I'll remove the said references as per your request. > > --- > > Documentation/devicetree/bindings/arm/davinci.txt | 4 ++ > > arch/arm/boot/dts/Makefile | 1 + > > arch/arm/boot/dts/omapl138-lcdk.dts | 71 +++++++++++++++++++++++ > > arch/arm/mach-davinci/da8xx-dt.c | 1 + > > 4 files changed, 77 insertions(+) > > create mode 100644 arch/arm/boot/dts/omapl138-lcdk.dts > > > > diff --git a/Documentation/devicetree/bindings/arm/davinci.txt b/Documentation/devicetree/bindings/arm/davinci.txt > > index cfaeda4..1482c74 100644 > > --- a/Documentation/devicetree/bindings/arm/davinci.txt > > +++ b/Documentation/devicetree/bindings/arm/davinci.txt > > @@ -5,6 +5,10 @@ DA850/OMAP-L138/AM18x Evaluation Module (EVM) board > > Required root node properties: > > - compatible = "ti,da850-evm", "ti,da850"; > > > > +DA850/OMAP-L138/AM18x L138/C6748 Development Kit (LCDK) board > > here too, drop reference to C6748. > Ditto. > > +Required root node properties: > > + - compatible = "ti,omapl138-lcdk", "ti,da850"; > > let the compatible be "ti,da850-lcdk" for consistency. > Kevin pointed that out. > > + > > EnBW AM1808 based CMC board > > Required root node properties: > > - compatible = "enbw,cmc", "ti,da850; > > diff --git a/arch/arm/boot/dts/Makefile b/arch/arm/boot/dts/Makefile > > index 414b427..da3f69b 100644 > > --- a/arch/arm/boot/dts/Makefile > > +++ b/arch/arm/boot/dts/Makefile > > @@ -105,6 +105,7 @@ dtb-$(CONFIG_ARCH_BERLIN) += \ > > dtb-$(CONFIG_ARCH_BRCMSTB) += \ > > bcm7445-bcm97445svmb.dtb > > dtb-$(CONFIG_ARCH_DAVINCI) += \ > > + omapl138-lcdk.dtb \ > > da850-enbw-cmc.dtb \ > > da850-evm.dtb > > dtb-$(CONFIG_ARCH_DIGICOLOR) += \ > > diff --git a/arch/arm/boot/dts/omapl138-lcdk.dts b/arch/arm/boot/dts/omapl138-lcdk.dts > > new file mode 100644 > > index 0000000..fad3b6d > > --- /dev/null > > +++ b/arch/arm/boot/dts/omapl138-lcdk.dts > > @@ -0,0 +1,71 @@ > > +/* > > + * Copyright (c) 2016 BayLibre, Inc. > > + * > > + * Licensed under GPLv2 or later. > > are you sure about "or later"? > I will remove it. Karl -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
