G'day Karl / Rob,
On 28/07/2016 05:08, Karl-Heinz Schneider wrote:
Am Mittwoch, den 27.07.2016, 09:46 -0500 schrieb Rob Herring:
On Mon, Jul 25, 2016 at 03:50:03PM +0800, Phil Reid wrote:
This patch added irq support for the SMBALERT pin and notification of
the battery removal / insertion. The sbs manager would typically be
used with the corresponding sbs-battery driver that currently uses a
gpio input for battery presence and interrupt. To remain compatible with
that existing driver this patch implements GPIO inputs with interrupt
support. IRQ masking is performed in software as the hardware does not
support masking of notifications from each battery.
In addition a power_supply change notification is generated for the sbs
manager device when the AC present flag is changed.
Tested with LTC1760 and dual sbs compatible batteries.
Please don't submit a binding and immediately turn around and add to it.
While that is often preferred for drivers or kernel features, bindings
should be complete as possible and not evolve. Combine this with your
previous patch add sbs-mgr if that hasn't been accepted yet.
That was from Karl. I'm happy to have this combined if he is.
IMO, the sbs-bat should just be a interrupt and making it and this
binding a GPIO is overkill. Since batteries nodes using this will be
new, there's no reason the driver can't be updated to support
interrupts.
Also, I'm not even convinced you need the sbs-mgr to be an
interrupt-controller. Is this anything more that just wire-OR'ed
interrupt lines which can be handled as shared irq? Does reading
SBSM_CMD_BATSYSSTATE have a side effect for example?
Yes, according to the Datasheed it clears SMBALERT#.
Yes you need to service the Ltc1760 for the irq to clear. reading the batteries does nothing.
Even without any batteries present you may get an irq and need to service it.
eg: I have a system with 2 ltc1760 with a total of 4 batteries.
So if only one battery is present and AC power is connected then both ltc1760 will generate
a notification on SMBALERT. One which has no batteries present.
Rob
SMBALERT is electrically an active low line which is pulled down by one
or more devices needing attention, isn't it? The I2C host driver or some
other instance need to implement support for it, the device driver may
register some sort of handler function (e.g by implementing struct
i2c_driver.alert function)
That's my understanding of the SMBALERT.
I once tried to implement the alert function and see if it get's called.
It didn't. At that point I didn't investigate further.
So, do I miss something or is that part incomplete/broken? I can only
find lm90 and ipmi_ssif which implement the callback.
I wasn't aware of that functionality. Most devices seem to use a GPIO to
obtain irq support. Which I guess is the most flexible solution.
I think SMBALERT also support a mechanism to query all devices on the bus to determine
which device address is asserting the irq. Not sure how this would work with multiplexed
address buses (eg dual ltc1760) and devices with the same address.
Open to suggestions
--
Regards
Phil Reid
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
