Hi Philipp,
On 07/04/2016 07:36 PM, Philipp Zabel wrote:
Am Montag, den 04.07.2016, 15:47 +0200 schrieb gabriel.fernandez@xxxxxx:
From: Maxime Coquelin <mcoquelin.stm32@xxxxxxxxx>
This adds documentation of device tree bindings for the
STM32 reset controller.
Signed-off-by: Maxime Coquelin <mcoquelin.stm32@xxxxxxxxx>
The way I understand Documentation/SubmittingPatches, this should also
have your Signed-off-by.
ok
---
.../devicetree/bindings/reset/st,stm32-rcc.txt | 50 ++++++++++++++++++++++
1 file changed, 50 insertions(+)
create mode 100644 Documentation/devicetree/bindings/reset/st,stm32-rcc.txt
diff --git a/Documentation/devicetree/bindings/reset/st,stm32-rcc.txt b/Documentation/devicetree/bindings/reset/st,stm32-rcc.txt
new file mode 100644
index 0000000..333080c
--- /dev/null
+++ b/Documentation/devicetree/bindings/reset/st,stm32-rcc.txt
@@ -0,0 +1,50 @@
+STMicroelectronics STM32 Peripheral Reset Controller
+====================================================
+
+The RCC IP is both a reset and a clock controller. This documentation only
+documents the reset part.
+
+Please also refer to reset.txt in this directory for common reset
+controller binding usage.
+
+Required properties:
+- compatible: Should be "st,stm32-rcc"
+- reg: should be register base and length as documented in the
+ datasheet
+- #reset-cells: 1, see below
+
+example:
+
+rcc: reset@40023800 {
+ #reset-cells = <1>;
+ compatible = "st,stm32-rcc";
+ reg = <0x40023800 0x400>;
+};
+
+Specifying softreset control of devices
+=======================================
+
+Device nodes should specify the reset channel required in their "resets"
+property, containing a phandle to the reset device node and an index specifying
+which channel to use.
+The index is the bit number within the RCC registers bank, starting from RCC
+base address.
+It is calculated as: index = register_offset / 4 * 32 + bit_offset.
+Where bit_offset is the bit offset within the register.
+For example, for CRC reset:
+ crc = AHB1RSTR_offset / 4 * 32 + CRCRST_bit_offset = 0x10 / 4 * 32 + 12 = 140
I see you decided to keep the register offset encoded in the reset
index.
+
+To simplify the usagen and to share bit definition with the clock driver of
s/usagen/usage/
ok
+the RCC IP, macros are available to generate the index in human-readble
+format.
+
+For STM32F4 series, the macro are available here:
+ - include/dt-bindings/mfd/stm32f4-rcc.h
If DT and ARM/STI and maintainers agree with the binding and header
macros, I'm inclined to take patches 1-3.
regards
Philipp
Thanks!
Best Regards
Gabriel
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
