Adapt qspi driver to use (get_buf/put_buf) pointers added
earlier.
These can be called just before the memcpy operations to get hold
of the memory mapped address and to turn on the controller clocks.
Signed-off-by: Sourav Poddar <sourav.poddar@xxxxxx>
---
drivers/spi/spi-ti-qspi.c | 17 +++++++++++++++++
1 files changed, 17 insertions(+), 0 deletions(-)
diff --git a/drivers/spi/spi-ti-qspi.c b/drivers/spi/spi-ti-qspi.c
index 2323572..10bcb37 100644
--- a/drivers/spi/spi-ti-qspi.c
+++ b/drivers/spi/spi-ti-qspi.c
@@ -247,6 +247,21 @@ static void ti_qspi_configure_from_slave(struct spi_device *spi, u8 *val)
ti_qspi_write(qspi, memval, QSPI_SPI_SETUP0_REG);
}
+static void ti_qspi_get_mem_buf(struct spi_master *master)
+{
+ struct ti_qspi *qspi = spi_master_get_devdata(master);
+
+ pm_runtime_get_sync(qspi->dev);
+ master->mem = qspi->mmap_base;
+}
+
+static void ti_qspi_put_mem_buf(struct spi_master *master)
+{
+ struct ti_qspi *qspi = spi_master_get_devdata(master);
+
+ pm_runtime_put(qspi->dev);
+}
+
static void ti_qspi_restore_ctx(struct ti_qspi *qspi)
{
struct ti_qspi_regs *ctx_reg = &qspi->ctx_reg;
@@ -515,6 +530,8 @@ static int ti_qspi_probe(struct platform_device *pdev)
master->dev.of_node = pdev->dev.of_node;
master->bits_per_word_mask = BIT(32 - 1) | BIT(16 - 1) | BIT(8 - 1);
master->configure_from_slave = ti_qspi_configure_from_slave;
+ master->get_buf = ti_qspi_get_mem_buf;
+ master->put_buf = ti_qspi_put_mem_buf;
if (!of_property_read_u32(np, "num-cs", &num_cs))
master->num_chipselect = num_cs;
--
1.7.1
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
