Hi, On 30 June 2016 at 12:04, Hans de Goede <hdegoede@xxxxxxxxxx> wrote: > Hi, > > > On 30-06-16 11:58, Kalle Valo wrote: >> >> Hans de Goede <hdegoede@xxxxxxxxxx> writes: >> >>> Hi, >>> >>> On 30-06-16 11:02, Kalle Valo wrote: >>>> >>>> Priit Laes <plaes@xxxxxxxxx> writes: >>>> >>>>>> What is the size of this nvram file? As it's board specific, I wonder >>>>>> if we can simply include it inside of the DT verbatim. I remember >>>>>> doing that (in the pre-dtb days, on real open firmware) for the >>>>>> "spidernet" >>>>>> ethernet driver. >>>>> >>>>> >>>>> It contains a bit too much info: >>>>> >>>>> This is what CubieTruck requires: >>>>> >>>>> >>>>> http://dl.cubieboard.org/public/Cubieboard/benn/firmware/ap6210/nvram_ap6210.txt >>>> >>>> >>>> In the nvram file I see lots of identifiers: >>>> >>>> manfid=0x2d0 >>>> prodid=0x492 >>>> vendid=0x14e4 >>>> devid=0x4343 >>>> boardtype=0x0598 >>>> boardrev=0x1307 >>>> boardnum=777 >>>> >>>> Are any of these (or a combination of them) unique for each board type? >>>> What if one of these is provided through DT and then the driver could >>>> choose the nvram file based on the board id? Just another idea... >>> >>> >>> That would require updating a table in the driver every time a new >>> board comes out, I do not believe that that is a good solution. >> >> >> You don't necessarily need to have a table in the driver if you embed >> the id to the filename, for example something like this: >> >> nvram-0598-1307.txt >> nvram-<boardtype>-<boardrev>.txt > > > Downside of this is, that as Arend already said, the nvram files are not > readily available. > > Typically the boards we are talking about are shipped with android, > and the mainline kernel bringup is done by a user, not the manufacturer. > > So the nvram file needs to be extracted from e.g. an android image, > having ap6210 in the filename allows the user to see that his module > (which is clearly labelled ap6210 is already supported, where as the > boardtype/boardrev magic numbers are a big unknown. > > So I believe that using a human readable string is better here. So then how about making use of a more specific compatible string? e.g. brcmf { compatible = "foo,ap6210", "brcm,bcm4329-fmac"; ... }; and if the compatible has more than one element you request FW_NAME_<compatible>.txt as the nvram file. Or try each comptible (and lastly no suffix) until you get a match. (AFAICT, this is what the "model" property was originally intended for anyway, but almost nobody did it right, and everyone put a user readable string into "model" for boards instead of the ePAPR defined compatible string). Regards Jonas -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
