This adds standard device tree bindings for a reset GPIO line, and
the VDDD and VDDA power regulators.
Cc: devicetree@xxxxxxxxxxxxxxx
Signed-off-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
---
Documentation/devicetree/bindings/iio/pressure/bmp085.txt | 11 +++++++++--
1 file changed, 9 insertions(+), 2 deletions(-)
diff --git a/Documentation/devicetree/bindings/iio/pressure/bmp085.txt b/Documentation/devicetree/bindings/iio/pressure/bmp085.txt
index d7a6deb6b21e..06ad5feaea28 100644
--- a/Documentation/devicetree/bindings/iio/pressure/bmp085.txt
+++ b/Documentation/devicetree/bindings/iio/pressure/bmp085.txt
@@ -1,7 +1,7 @@
-BMP085/BMP18x digital pressure sensors
+BMP085/BMP18x/BMP28x digital pressure sensors
Required properties:
-- compatible: bosch,bmp085
+- compatible: "bosch,bmp085" or "bosch,bmp180" or "bosch,bmp280"
Optional properties:
- chip-id: configurable chip id for non-default chip revisions
@@ -10,6 +10,10 @@ Optional properties:
value range is 0-3 with rising sensitivity.
- interrupt-parent: should be the phandle for the interrupt controller
- interrupts: interrupt mapping for IRQ
+- reset-gpios: a GPIO line handling reset of the sensor: as the line is
+ active low, it should be marked GPIO_ACTIVE_LOW (see gpio/gpio.txt)
+- vddd-supply: digital voltage regulator (see regulator/regulator.txt)
+- vdda-supply: analog voltage regulator (see regulator/regulator.txt)
Example:
@@ -21,4 +25,7 @@ pressure@77 {
default-oversampling = <2>;
interrupt-parent = <&gpio0>;
interrupts = <25 IRQ_TYPE_EDGE_RISING>;
+ reset-gpios = <&gpio0 26 GPIO_ACTIVE_LOW>;
+ vddd-supply = <&foo>;
+ vdda-supply = <&bar>;
};
--
2.4.11
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
