> + the chip select signal. > + Minimum value is 1 (0 treated as 1). > + > +- ti,cs-wsetup: write setup width, ns > + Time between the beginning of a memory cycle > + and the activation of write strobe. > + Minimum value is 1 (0 treated as 1). > + > +- ti,cs-wstrobe: write strobe width, ns > + Time between the activation and deactivation of > + the write strobe. > + Minimum value is 1 (0 treated as 1). > + > +- ti,cs-whold: write hold width, ns > + Time between the deactivation of the write > + strobe and the end of the cycle (which may be > + either an address change or the deactivation of > + the chip select signal. > + Minimum value is 1 (0 treated as 1). > + > +If any of the above parameters are absent, current parameter value will be taken > +from the corresponding HW reg. > + > +The name for cs node must be in format csN, where N is the cs number. this is wired we should use reg instead to represent the cs as done for SPI or a an other property Best Regards, J. -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
