Signed-off-by: Rich Felker <dalias@xxxxxxxx> --- Documentation/devicetree/bindings/jcore/cpus.txt | 91 ++++++++++++++++++++++++ 1 file changed, 91 insertions(+) create mode 100644 Documentation/devicetree/bindings/jcore/cpus.txt diff --git a/Documentation/devicetree/bindings/jcore/cpus.txt b/Documentation/devicetree/bindings/jcore/cpus.txt new file mode 100644 index 0000000..00ef112 --- /dev/null +++ b/Documentation/devicetree/bindings/jcore/cpus.txt @@ -0,0 +1,91 @@ +=================== +J-Core cpu bindings +=================== + +The J-Core processors are open source CPU cores that can be built as FPGA +soft cores or ASICs. The device tree is also responsible for describing the +cache controls and, for SMP configurations, all details of the SMP method, +as documented below. + + +--------------------- +Top-level "cpus" node +--------------------- + +Required properties: + +- #address-cells: Must be 1. + +- #size-cells: Must be 0. + +Optional properties: + +- enable-method: Required only for SMP systems. If present, must be + "jcore,spin-table". + + +-------------------- +Individual cpu nodes +-------------------- + +Required properties: + +- device_type: Must be "cpu". + +- compatible: Must be "jcore,j2". + +- reg: Must be 0 on uniprocessor systems, or the sequential, zero-based + hardware cpu id on SMP systems. + +Optional properties: + +- clock-frequency: Clock frequency of the cpu in Hz. + +- cpu-release-addr: Necessary only for secondary processors on SMP systems + using the "jcore,spin-table" enable method. If present, must consist of + two cells containing physical addresses. The first cell contains an + address which, when written, unblocks the secondary cpu. The second cell + contains an address from which the cpu will read its initial program + counter when unblocked. + + +--------------------- +Cache controller node +--------------------- + +Required properties: + +- compatible: Must be "jcore,cache". + +- reg: A memory range for the cache controller registers. + + +-------- +IPI node +-------- + +Device trees for SMP systems must have an IPI node representing the mechanism +used for inter-processor interrupt generation. + +Required properties: + +- compatible: Must be "jcore,ipi-controller". + +- reg: A memory range used to IPI generation. + +- interrupts: An irq on which IPI will be received. + + +---------- +CPUID node +---------- + +Device trees for SMP systems must have a CPUID node representing the mechanism +used to identify the current processor on which execution is taking place. + +Required properties: + +- compatible: Must be "jcore,cpuid-mmio". + +- reg: A memory range containing a single 32-bit mmio register which produces + the current cpu id when read. -- 2.8.1 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
