Re: [PATCH RFT 1/2] phylib: add device reset GPIO support

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




Hello.

On 05/10/2016 09:32 PM, Florian Fainelli wrote:

The PHY devices sometimes do have their reset signal (maybe even power
supply?) tied to some GPIO and sometimes it also does happen that a boot
loader does not leave it deasserted. So far this issue has been attacked
from (as I believe) a wrong angle: by teaching the MAC driver to manipulate
the GPIO in question; that solution, when applied to the device trees, led
to adding the PHY reset GPIO properties to the MAC device node, with one
exception: Cadence MACB driver which could handle the "reset-gpios" prop
in a PHY device subnode. I believe that the correct approach is to teach
the 'phylib' to get the MDIO device reset GPIO from the device tree node
corresponding to this device -- which this patch is doing...

Note that I had to modify the  AT803x PHY driver as it would stop working
otherwise as it made use of the reset GPIO for its own purposes...

Signed-off-by: Sergei Shtylyov <sergei.shtylyov@xxxxxxxxxxxxxxxxxx>

This looks good to me:

Acked-by: Florian Fainelli <f.fainelli@xxxxxxxxx>

   Thank you! I'll send v3 without [RFT] then.

Can you follow up with changes in phy_{suspend,resume}

   I'm not sure what changes you mean -- powering down the PHYs?

if that is also
an use case that you have?

   No, I'm not into power management.

MBR, Sergei

--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]
  Powered by Linux