Hi Krzysztof, On 04/29/2016 12:59 PM, Krzysztof Kozlowski wrote: > Hi, > > Patches are independent, please pick up as you wish. > > However all of them are needed to solve the issue, so I am sending > everything together for easier testng. > > > Problem > ======= > When Odroid U3 (usb3503 + smsc95xx + max77686) boots from network (TFTP), > the usb3503 does not show up in "lsusb". Hard-reset is required, e.g. > by suspend to RAM. The actual TFTP boot does not have to happen. Just > "usb start" from U-Boot is sufficient. > > > Solution > ======== > Perform real hardware reset (including regulator off/on) when probing. > > > Tested on Odroid U3 so far. Please kindly test on X2 and other > configurations and bootloaders. Against which kernel git repo is this patch? I did apply this patch series first: http://www.spinics.net/lists/arm-kernel/msg500764.html followed by this patch series. I've tested with both 4.6.0-rc2 and -rc5, but in all cases (even without applying these patches!) the boot sequence hangs here: ... [drm] Exynos DRM: using 12c10000.mixer device for DMA mapping operations exynos-drm exynos-drm: bound 12c10000.mixer (ops mixer_component_ops) exynos-drm exynos-drm: bound 12d00000.hdmi (ops hdmi_component_ops) [drm] Supports vblank timestamp caching Rev 2 (21.10.2013). [drm] No driver support for vblank timestamp query. Console: switching to colour frame buffer device 240x67 exynos-drm exynos-drm: fb0: frame buffer device [drm] Initialized exynos 1.0.0 20110530 on minor 0 brd: module loaded loop: module loaded s3c64xx-spi 13930000.spi: spi bus clock parent not specified, using clock at index 0 as parent s3c64xx-spi 13930000.spi: number of chip select lines not specified, assuming 1 chip select line tun: Universal TUN/TAP device driver, 1.6 tun: (C) 1999-2004 Max Krasnyansky <maxk@xxxxxxxxxxxx> usbcore: registered new interface driver asix usbcore: registered new interface driver ax88179_178a usbcore: registered new interface driver cdc_ether usbcore: registered new interface driver smsc95xx usbcore: registered new interface driver cdc_ncm dwc2 12480000.hsotg: Specified GNPTXFDEP=1024 > 768 dwc2 12480000.hsotg: EPs: 16, dedicated fifos, 7808 entries in SPRAM ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver ehci-exynos: EHCI EXYNOS driver exynos-ehci 12580000.ehci: EHCI Host Controller exynos-ehci 12580000.ehci: new USB bus registered, assigned bus number 1 exynos-ehci 12580000.ehci: irq 51, io mem 0x12580000 exynos-ehci 12580000.ehci: USB 2.0 started, EHCI 1.00 usb usb1: New USB device found, idVendor=1d6b, idProduct=0002 usb usb1: New USB device strings: Mfr=3, Product=2, SerialNumber=1 usb usb1: Product: EHCI Host Controller usb usb1: Manufacturer: Linux 4.6.0-rc5-odroid ehci_hcd usb usb1: SerialNumber: 12580000.ehci hub 1-0:1.0: USB hub found hub 1-0:1.0: 3 ports detected ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver ohci-exynos: OHCI EXYNOS driver usbcore: registered new interface driver usb-storage usb3503 0-0008: switched to HUB mode usb3503 0-0008: usb3503_probe: probed in hub mode using random self ethernet address using random host ethernet address usb0: HOST MAC 66:79:ef:11:72:85 usb0: MAC 1e:66:f2:66:8e:2a using random self ethernet address using random host ethernet address g_ether gadget: Ethernet Gadget, version: Memorial Day 2008 g_ether gadget: g_ether ready dwc2 12480000.hsotg: bound driver g_ether mousedev: PS/2 mouse device common for all mice max77686-rtc max77686-rtc: rtc core: registered max77686-rtc as rtc0 i2c /dev entries driver s5p-fimc-md camera: Entity type for entity FIMC.0 was not initialized! usb 1-2: new high-speed USB device number 2 using exynos-ehci usb 1-2: New USB device found, idVendor=0424, idProduct=9730 usb 1-2: New USB device strings: Mfr=0, Product=0, SerialNumber=0 smsc95xx v1.0.4 smsc95xx 1-2:1.0 eth0: register 'smsc95xx' at usb-12580000.ehci-2, smsc95xx USB 2.0 Ethernet, c2:22:09:f2:5f:e8 usb 1-3: new high-speed USB device number 3 using exynos-ehci usb 1-3: New USB device found, idVendor=0424, idProduct=3503 usb 1-3: New USB device strings: Mfr=0, Product=0, SerialNumber=0 hub 1-3:1.0: USB hub found hub 1-3:1.0: 3 ports detected No oops, no nothing. It's just sitting there. Is this a regression that was introduced in 4.6? Or is there some special new config that needs to be turned on first in 4.6? I've been running 4.5.0-rc3 before this, but I can't apply these patches there because there is no drivers/regulator/max77686-regulator.c in 4.5. Regards, Hans > > > Best regards, > Krzysztof > > Krzysztof Kozlowski (3): > usb: misc: usb3503: Fix HUB mode after bootloader initialization > ARM: dts: exynos: Provide regulator for usb3503 on Odroid to fix > device detection > regulator: max77686: Configure enable time to properly handle > regulator enable > > Documentation/devicetree/bindings/usb/usb3503.txt | 1 + > arch/arm/boot/dts/exynos4412-odroidu3.dts | 2 + > drivers/regulator/max77686-regulator.c | 5 ++ > drivers/usb/misc/usb3503.c | 81 +++++++++++++++++++++++ > 4 files changed, 89 insertions(+) > -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
