On Wed, Mar 23, 2016 at 8:48 PM, Srinivas Kandagatla <srinivas.kandagatla@xxxxxxxxxx> wrote: > + led@1 { > + label = "dragonboard-600c:green:user1"; > + gpios = <&tlmm_pinmux 3 GPIO_ACTIVE_HIGH>; > + linux,default-trigger = "heartbeat"; > + default-state = "off"; > + }; > + > + led@2 { > + label = "dragonboard-600c:green:user2"; > + gpios = <&tlmm_pinmux 7 GPIO_ACTIVE_HIGH>; > + linux,default-trigger = "mmc0"; > + default-state = "off"; > + }; > + > + led@3 { > + label = "dragonboard-600c:green:user3"; > + gpios = <&tlmm_pinmux 10 GPIO_ACTIVE_HIGH>; > + linux,default-trigger = "mmc1"; > + default-state = "off"; > + }; > + > + led@4 { > + label = "apq8016-sbc:green:user4"; typo ^^ > + gpios = <&tlmm_pinmux 11 GPIO_ACTIVE_HIGH>; > + linux,default-trigger = "none"; > + default-state = "off"; > + }; also, if i read the 96boards specs correctly, the LED are labeled 3-2-1-0 , if you look at the board with the LEDs on the bottom. With this DT config, you end up with 0-1-2-3 instead. also, they should be labeled 0 to 3, not 1 to 4. -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html