This patch adds a new optional DT property which enables an alternative
way of supporting memory size above 16MiB (128Mib). This new mechanism
translates the regular 3byte-address op codes into their 4byte-address
version whereas the old/default mecanism makes the SPI memory enter its
4byte-address mode, which has annoying side effects for early bootloaders.
We cannot discover at run time whether the SPI NOR memory supports the
4byte-address op codes. For instance both Macronix MX25L25635E and
MX25L25673G share the same JEDEC ID (C22019 without any extension byte).
However the first one doesn't support 4byte-address op codes whereas the
second one does.
Signed-off-by: Cyrille Pitchen <cyrille.pitchen@xxxxxxxxx>
---
Documentation/devicetree/bindings/mtd/jedec,spi-nor.txt | 11 +++++++++++
1 file changed, 11 insertions(+)
diff --git a/Documentation/devicetree/bindings/mtd/jedec,spi-nor.txt b/Documentation/devicetree/bindings/mtd/jedec,spi-nor.txt
index 2c91c03e7eb0..8be610482089 100644
--- a/Documentation/devicetree/bindings/mtd/jedec,spi-nor.txt
+++ b/Documentation/devicetree/bindings/mtd/jedec,spi-nor.txt
@@ -66,6 +66,17 @@ Optional properties:
Refer to your chips' datasheet to check if this is supported
by your chip.
+- m25p,4byte-opcodes: For memory size above 16MiB (128Mib), use the dedicated
+ 4byte-address opcodes instead of entering the 4byte
+ address mode. This mode changes the internal state of the
+ chip so may conflict with some early boot loaders, which
+ expect to use the regular (Fast) Read opcodes with 3byte
+ address.
+ However 4byte-address opcodes are not supported by all
+ chips and support for them can not be detected at runtime.
+ Refer to you chip's datasheet to check if this is
+ supported by your chip.
+
Example:
flash: m25p80@0 {
--
1.8.2.2
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
