This adds documentation for the MediaTek Global Command Engine (GCE) unit
found in MT8173 SoCs.
Signed-off-by: HS Liao <hs.liao@xxxxxxxxxxxx>
---
.../devicetree/bindings/soc/mediatek/gce.txt | 34 ++++++++++++++++++++
1 file changed, 34 insertions(+)
create mode 100644 Documentation/devicetree/bindings/soc/mediatek/gce.txt
diff --git a/Documentation/devicetree/bindings/soc/mediatek/gce.txt b/Documentation/devicetree/bindings/soc/mediatek/gce.txt
new file mode 100644
index 0000000..eff07e2
--- /dev/null
+++ b/Documentation/devicetree/bindings/soc/mediatek/gce.txt
@@ -0,0 +1,34 @@
+MediaTek GCE
+===============
+
+The Global Command Engine (GCE) is used to help read/write registers with
+critical time limitation, such as updating display configuration during the
+vblank. The GCE can be used to implement the Command Queue (CMDQ) driver.
+
+Required properties:
+- compatible: Must be "mediatek,mt8173-gce"
+- reg: Address range of the GCE unit
+- interrupts: The interrupt signal from the GCE block
+- clock: Clocks according to the common clock binding
+- clock-names: Must be "gce" to stand for GCE clock
+
+Required properties for a client device:
+- mediatek,gce: Should point to the respective GCE block
+
+Example:
+
+ gce: gce@10212000 {
+ compatible = "mediatek,mt8173-gce";
+ reg = <0 0x10212000 0 0x1000>;
+ interrupts = <GIC_SPI 135 IRQ_TYPE_LEVEL_LOW>;
+ clocks = <&infracfg CLK_INFRA_GCE>;
+ clock-names = "gce";
+ };
+
+Example for a client device:
+
+ mmsys: clock-controller@14000000 {
+ compatible = "mediatek,mt8173-mmsys";
+ mediatek,gce = <&gce>;
+ ...
+ };
--
1.7.9.5
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
