Hi, On Wednesday 06 November 2013 05:37 AM, Jingoo Han wrote: > On Wednesday, November 06, 2013 2:58 AM, Vivek Gautam wrote: >> On Tue, Nov 5, 2013 at 5:33 PM, Jingoo Han <jg1.han@xxxxxxxxxxx> wrote: > > [.....] > >>> USB3.0 PHY consists of two blocks such as 3.0 block and 2.0 block. >>> This USB3.0 PHY can support UTMI+ and PIPE3 interface for 3.0 block >>> and 2.0 block, respectively. >>> >>> Conclusion: >>> >>> 1) USB2.0 PHY: USB2.0 HOST, USB2.0 Device >>> Base address: 0x1213 0000 >>> >>> 2) USB3.0 PHY: USB3.0 DRD (3.0 HOST & 3.0 Device) >>> Base address: 0x1210 0000 >>> 2.0 block(UTMI+) & 3.0 block(PIPE3) >> >> And this is of course the PHY used by DWC3 controller, which works at >> both High speed as well as Super Speed. >> Right ? > > Right. > > While 3.0 block(PIPE3) can be used for Super Speed, 2.0 block(UTMI+) > can be used for High speed. It should then come under *single IP muliple PHY* category similar to what Sylwester has done. Thanks Kishon -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html